Unit of competency Outline

Date retreived
22/07/2026 1:29 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Interpret and produce curved 3D shapes and patterns

Interpret and produce curved 3D shapes and patterns

Unit of competency
National Code
MEM09216
State Code
OEV28
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
19/12/2022
View on TGA
State Implementation and Classification
Approved Date
19/04/2023
Field of Education
039999 - Engineering And Related Technologies, N.e.c.
Original Release Date
19/04/2023
Nominal Hours
36
Description
This unit of competency defines the skills and knowledge required to produce drawings of curved 3D shapes and patterns either manually or using computer-aided design (CAD) system.It applies to drawing and lofting techniques to create 3D line plan drawings used within a marine vessel construction setting. Tasks may relate to drawings for hull designs, section development including curved and raking transom, conical development, camber development methods and general arrangement plans.No licensing, legislative or certification requirements apply to this unit at the time of publication
Notes
Elements and Performance Criteria
1. Determine drawing/lofting requirements
  • 1.1 Follow standard operating procedures (SOPs) and comply with work health and safety (WHS) requirements at all times
  • 1.2 Confirm purpose, scope and information requirements for task
  • 1.3 Interpret available information relevant to project and work requirements, and identify and address further information needs
  • 1.4 Identify and prepare equipment required to complete work
  • 1.5 Identify and apply relevant codes, standards and symbols relevant to work
  • 1.6 Consult appropriate personnel to ensure the work is coordinated effectively with others involved in the project
2. Apply lofting (drafting) procedures
  • 2.1 Apply workplace procedures to retrieve and apply required information
  • 2.2 Set up drawing equipment and accessories to suit job requirements
  • 2.3 Identify and apply drafting or lofting procedures to suit specified drawing requirements
  • 2.4 Record alterations required to offset measurements as applicable
  • 2.5 Produce loftings that are consistent with work and industry requirements
3. Submit lines and plan drawings
  • 3.1 Ensure work meets specifications and submit drawings in accordance with SOPs
  • 3.2 Supply any required altered offset measurements and relevant information related to drawing
No information
No information
Replaces
State Code National Code Title Type
WE071 MEM09216A Interpret and produce curved 3-D shapes and patterns Unit of competency
State Code National Code Title Type
BIW7 MEM50222 Diploma of Engineering - Technical Qualification
BIW9 MEM40422 Certificate IV in Engineering Drafting Qualification