Unit of competency Outline

Date retreived
22/07/2026 8:10 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Complete a basic glass and glazing project

Complete a basic glass and glazing project

Unit of competency
National Code
MSFGG1001
State Code
WI472
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
040323 - Glazing
Original Release Date
19/06/2014
Nominal Hours
80
Description
This unit of competency covers preparing, fabricating and assembling a basic glass and glazing project. It is designed for VET in Schools or pre-employment programs to introduce basic glass and glazing techniques and materials.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Prepare for work
  • 1.1 Work instructions are used to determine job requirements for a basic glass and glazing job, including design variations, tolerances, process, materials, finish and quantity
  • 1.2 Work sequence is planned and procedures are determined for checking quality at each stage of the process
  • 1.3 Work health and safety requirements (WHS), including personal protective equipment, are observed throughout the work
  • 1.4 Preparatory drawings/set-outs for tasks are confirmed and a suitable work area selected
  • 1.5 Materials are selected following work instructions
  • 1.6 Tools and equipment and a table suitable for the work are identified and checked for safe and effective operation
2 Fabricate and assemble components
  • 2.1 Material is set out according to work instructions, prepared, and components marked according to workplace procedures
  • 2.2 Tools, machines and equipment are used in accordance with safety requirements and manufacturer specifications
  • 2.3 Components are fabricated, including any specified shapes, angles or curves, and checked against set-out and job requirements
  • 2.4 Components are fitted to job requirements and the assembly process undertaken according to workplace procedures
  • 2.5 Item is checked for compliance with specifications and finished in accordance with work instructions using edging equipment, where required
3 Finalise operation and maintain equipment
  • 3.1 Work area is cleaned, hand and/or power tools and equipment are cleaned, maintained and stored in accordance with workplace procedures
  • 3.2 Off-cuts and unused materials are collected and stored for re-use or disposed of following workplace procedures
  • 3.3 Waste and scrap materials are dealt with following workplace procedures
No information
No information
No information
State Code National Code Title Type
J724 MSF10113 Certificate I in Furnishing Qualification