Unit of competency Outline

Date retreived
23/07/2026 4:59 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Cut veneer

Cut veneer

Unit of competency
National Code
FWPWPP2208
State Code
AXJ44
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
1.00
Current Release Date
13/05/2016
View on TGA
State Implementation and Classification
Approved Date
05/10/2016
Field of Education
030111 - Wood MacHining And Turning
Original Release Date
05/10/2016
Nominal Hours
10
Description
This unit of competency describes the outcomes required to cut veneer to width and length in readiness for bonding to panel products.The unit applies to production workers who cut veneer in a forest and wood products factory setting.No licensing, legislative, regulatory, or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for cutting
  • 1.1 Review work order and where required check with appropriate personnel.
  • 1.2 Select appropriate personal protective equipment and check for operational effectiveness.
  • 1.3 Obtain type and quantity of veneer to be cut from veneer production process.
  • 1.4 Select cutting process and plan in line with work order.
2. Operate equipment to cut veneer
  • 2.1 Use equipment in line with organisational safety procedures, manufacturer’s instructions and environmental protection practices.
  • 2.2 Complete pre start up equipment checks to ensure operational effectiveness.
  • 2.3 Coordinate conveyor and guillotine operation with veneer production.
  • 2.4 Select optimal cutting positions to minimise defects and maximise full width sheets.
  • 2.5 Complete cutting and monitor conveyor feed rate regularly for material flow problems.
  • 2.6 Cut veneer to specification and assess veneer visually throughout cutting process for strength, gaps and defects.
3. Redistribute material
  • 3.1 Direct material to storage or processing operations in line with organisational procedures.
  • 3.2 Dispose of incorrect cuts, off cuts and defective material in line with environmental protection practices.
  • 3.3 Clean work area in line with organisational safety procedures.
  • 3.4 Record and report production outcomes and equipment faults to appropriate personnel.
No information
No information
Replaces
State Code National Code Title Type
D6112 FPIWPP2208B Cut veneer Unit of competency
State Code National Code Title Type
BAK9 FWP20416 Certificate II in Wood Panel Products Qualification