Unit of competency Outline

Date retreived
23/07/2026 12:07 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Punch peg holes in panels

Punch peg holes in panels

Unit of competency
National Code
FWPWPP3208
State Code
AXJ33
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
1.00
Current Release Date
13/05/2016
View on TGA
State Implementation and Classification
Approved Date
05/10/2016
Field of Education
030111 - Wood MacHining And Turning
Original Release Date
05/10/2016
Nominal Hours
10
Description
This unit of competency describes the outcomes required to punch peg holes in thin panel products to produce a peg board, using a hole punching machine.The unit applies to production operators and technicians who punch peg holes in panels in a forest and wood products factory setting and includes operator maintenance.No licensing, legislative, regulatory, or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for hole punching
  • 1.1 Review work order and where required check with appropriate personnel.
  • 1.2 Select appropriate personal protective equipment and check for operational effectiveness.
  • 1.3 Obtain type and quantity of material to be punched from storage location.
  • 1.4 Plan punching process and hole lay out in line with work order.
2. Punch peg holes
  • 2.1 Use equipment in line with organisational safety procedures, manufacturer’s instructions and environmental protection practices.
  • 2.2 Complete pre start-up equipment checks to ensure operational effectiveness.
  • 2.3 Feed material into machine at prescribed feed rate.
  • 2.4 Follow punching sequence, and adjust to produce required quantity and maximum feed rate.
  • 2.5 Check punching process regularly and adjust to maintain desired quality and output.
  • 2.6 Dispose of sub-standard material in line with environmental protection practices.
  • 2.7 Stack material safely in designated location in line with work order.
3. Complete operator maintenance
  • 3.1 Follow organisational safety procedures to lock out equipment.
  • 3.2 Check punches for bluntness or damage.
  • 3.3 Remove and replace punches in line with manufacturer's recommendations.
  • 3.4 Keep machine area clear of dust and debris in line with organisational safety procedures.
  • 3.5 Record and report production outcomes, equipment faults and maintenance requirements to appropriate personnel.
No information
No information
Replaces
State Code National Code Title Type
D6123 FPIWPP3208B Punch peg holes in panels Unit of competency
State Code National Code Title Type
BAL3 FWP30416 Certificate III in Wood Panel Products Qualification