Unit of competency Outline

Date retreived
22/07/2026 2:12 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Develop control of tuning hammers

Develop control of tuning hammers

Unit of competency
National Code
MSFPT3009
State Code
WI607
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
030199 - Manufacturing Engineering And Technology, N.e.c.
Original Release Date
19/06/2014
Nominal Hours
25
Description
This unit of competency covers controlling tuning hammers by moving the tuning pins in very small increments accurately. It applies in workplace and on-site environments for small to large scale enterprise.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Plan for using tuning hammers
  • 1.1 Work health and safety (WHS) requirements, legislative requirements and workplace practices relevant to tuning pianos are verified and complied with
  • 1.2 Communication with others involved with the work is established and maintained to ensure efficient work flow, coordination, personnel cooperation and safety
  • 1.3 Written instructions are followed
2 Select tools and equipment
  • 2.1 Tools and equipment are selected consistent with the needs of the job
  • 2.2 Selected tools and equipment are checked for service ability and safety, and any faults repaired and reported according to workplace practices
  • 2.3 Personal protective equipment is correctly fitted and used
3 Set pin in specified position
  • 3.1 Correct posture for tuning is demonstrated which minimises fatigue and promotes muscular control
  • 3.2 Pin is set at desired pitch utilising a pitch standard, within accuracy constraints to + or – 0.5 cents
  • 3.3 Key is struck using stabilising blows
  • 3.4 Coordinated motor and auditory reflexes are demonstrated throughout tuning
  • 3.5 Strings are tuned and stabilised using appropriate techniques
4 Clean up work area
  • 4.1 All tools, materials and other equipment are checked, cleaned and returned to their appropriate location
  • 4.2 Work area is cleared and waste removed
  • 4.3 Workplace documentation is completed and filed
No information
No information
Replaced By
State Code National Code Title Type
OEL84 MSFPT4007 Control tuning hammers Unit of competency
State Code National Code Title Type
J740 MSF31213 Certificate III in Piano Technology Qualification
AB649 MSFSS00001 Piano Tuning Skill Set Skill set