Unit of competency Outline

Date retreived
22/07/2026 11:35 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Mould composites with chemically-resistant or fire-retardant properties

Mould composites with chemically-resistant or fire-retardant properties

Unit of competency
National Code
PMBTECH404E
State Code
ODB47
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
18/02/2021
View on TGA
State Implementation and Classification
Approved Date
19/05/2021
Field of Education
030305 - Materials Engineering
Original Release Date
19/05/2021
Nominal Hours
40
Description
This unit describes the skills and knowledge required to laminate special-purpose chemically-resistant and fire-retardant composite products in a production environment or on location.This unit applies to an experienced technician working alone or as part of a team.The unit principally refers to an additional set of materials science knowledge gained by a technician in the context of prior experience relating to composites with thermoset resins and fibre, mat or fillers reinforcement.No licensing or certification requirements exist at the time of publication. Relevant legislation, industry standards and codes of practice within Australia must be applied.
Notes
Elements and Performance Criteria
1. Confirm product specifications
  • 1.1 Confirm conditions of use, job specifications and other special requirements of desired composite product
  • 1.2 Obtain required authorisations of job specifications to enable product development to proceed
2. Select materials/process to produce desired composite product
  • 2.1 Identify required laminate properties, resin, matrix and other materials from job specifications
  • 2.2 Select production process to be followed that will produce product that meets specifications
  • 2.3 Implement measures to control identified hazards that may impact production processes
  • 2.4 Produce trial samples as required and arrange testing of samples to ensure output meets requirements
  • 2.5 Verify suitability of combination of materials and process against job specifications
  • 2.6 Complete pre-operational checks according to workplace procedures
3. Lay-up or mould laminate
  • 3.1 Correctly prepare and apply mould release to mould surface
  • 3.2 Clean and prepare structure surface for adhesion
  • 3.3 Apply laminate materials to mould or to structure
  • 3.4 Inspect or test laminate surface to ensure output meets specifications
  • 3.5 Make adjustments to remedy nonconforming outputs until desired output is achieved
  • 3.6 Apply waste management strategies and adjust processes to minimise scrap and waste according to workplace procedures
  • 3.7 Clean, adjust and lubricate equipment according to equipment instructions
4. Anticipate and solve process control variances
  • 4.1 Recognise existing or potential process control variances and their causes
  • 4.2 Determine, prioritise and implement remedial and preventative actions based on identified issues and causes
  • 4.3 Monitor process control variances and corrective actions taken until resolved
  • 4.4 Accurately maintain records and logbooks
No information
No information
Replaces
State Code National Code Title Type
BAI02 PMBTECH404 Mould chemical resistant and/or fire retardant fibre-composites Unit of competency