Unit of competency Outline

Information current as of
22/10/2026 1:51 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Install basic masonry structures

Install basic masonry structures

Unit of competency
National Code
SIFCBGM004
State Code
WG584
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
1.00
Current Release Date
21/06/2013
View on TGA
State Implementation and Classification
Approved Date
14/08/2013
Original Release Date
21/06/2013
Nominal Hours
40
Field of Education
040309 - Bricklaying And Stonemasonry
Description
This unit describes the performance outcome, skills and knowledge required to carry out basic masonry work for rockeries, monument footings and other grounds work. It applies to general grounds maintenance staff. It involves working under routine supervision and performing work according to work health and safety, relevant legislation and workplace policies and procedures.No licensing, legislative or certification requirements apply to this unit at the time of publication.
General notes
N/A
Elements and Performance Criteria
1. Plan work.
  • 1.1 Liaise with supervisor or team member to identify and confirm work requirements.
  • 1.2 Identify and select tools and equipment according to drawings and specifications.
  • 1.3 Check tools and equipment for serviceability and report faults.
  • 1.4 Prepare and use personal protective equipment.
  • 1.5 Identify unsafe tools and equipment and take corrective action.
2. Select and prepare materials.
  • 2.1 Select concrete masonry according to quality requirements and job specifications.
  • 2.2 Prepare concrete masonry for cutting and trimming.
  • 2.3 Select materials for mortar according to job specifications.
  • 2.4 Interpret manufacturer guidelines to prepare mortar mix according to job specifications and transport to job location.
  • 2.5 Finalise adjustments to materials according to specifications.
3. Lay masonry.
  • 3.1 Determine and apply required quantity of mortar evenly to job and set out.
  • 3.2 Lay masonry to line, level, plumb and specified bond pattern and cornering.
  • 3.3 Complete masonry work according to job drawings and specifications.
  • 3.4 Erect scaffolding according to work requirements and relevant legislation.
  • 3.5 Finish joints and brush down face work.
4. Install reinforcement to masonry.
  • 4.1 Place and lay reinforcement with bed joints according to job specifications.
  • 4.2 Place steel rods for vertical reinforcement to hollow work in locations according to job specifications.
  • 4.3 Carry out jointing or splicing of reinforcing according to engineer specifications.
  • 4.4 Mix, place and compact concrete or mortar to hollow block work.
5. Clean site.
  • 5.1 Remove waste and clear area according to workplace requirements.
  • 5.2 Clean, maintain and store tools and equipment according to manufacturer guidelines and workplace requirements.
No information
No information
No information