Unit of competency Outline

Date retreived
23/07/2026 5:36 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Cross cut materials with a fixed saw

Cross cut materials with a fixed saw

Unit of competency
National Code
FWPCOT2263
State Code
OCR81
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
04/12/2020
View on TGA
State Implementation and Classification
Approved Date
07/04/2021
Field of Education
030111 - Wood MacHining And Turning
Original Release Date
07/04/2021
Nominal Hours
15
Description
This unit of competency describes the skills and knowledge required to position and saw timber pieces and timber packs with a fixed circular saw or fixed chainsaw. The unit includes preparing for work, cross cutting timber materials to industry standard lengths, maximising volume and quality of recovery material, and performing routine operator maintenance.The unit applies to individuals who cross cut materials with a fixed saw in a timber yard and timber products manufacturing setting.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for work
  • 1.1 Determine job requirements from work order or instruction and, where required, seek clarification from appropriate personnel
  • 1.2 Confirm safety requirements for the job according to workplace health and safety procedures
  • 1.3 Identify, assess and take actions to mitigate risks and hazards associated with using a fixed saw
  • 1.4 Identify workplace environmental protection procedures for minimising and disposing of waste material, recycling and reusing materials, and cleaning tools and equipment
  • 1.5 Consult with team members and other appropriate personnel to ensure that work is coordinated effectively with others in the workplace
  • 1.6 Locate saw and other support equipment needed for the work, and check for correct operation and safety
  • 1.7 Select, fit and use personal protective equipment
  • 1.8 Conduct pre-start-up checks of saw to determine serviceability according to manufacturer instructions
2. Cross cut material
  • 2.1 Assess material visually to identify defects that may present unsafe work conditions, and review cut
  • 2.2 Cut material within workplace tolerances for length and angle relative to centre line
  • 2.3 Use cutting techniques to industry standard lengths, maximising volume and quality of recovery material
  • 2.4 Operate fixed saw effectively according to manufacturer recommendations
  • 2.5 Check and clear work area regularly according to workplace health and safety requirements and site procedures
  • 2.6 Dispose of sub-standard material according to workplace procedures and environmental requirements
  • 2.7 Identify and report problems with operation of saw according to workplace procedures
3. Perform routine operator maintenance
  • 3.1 Lock out, clean and maintain fixed saw according to manufacturer recommendations and workplace procedures
  • 3.2 Identify blunt or damaged saws and replace or sharpen, according to workplace procedures and manufacturer recommendations
  • 3.3 Record and report fixed saw operations and maintenance to appropriate personnel
No information
No information
Replaces
State Code National Code Title Type
AXL85 FWPCOT2218 Cross cut materials with a fixed saw Unit of competency