Unit of competency Outline

Date retreived
22/07/2026 2:43 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Rearrange large size copper cable

Rearrange large size copper cable

Unit of competency
National Code
ICTCBL319
State Code
AWK41
TGA Status
Current
DTWD Status
Approved
Current Release Number
2.00
Current Release Date
30/08/2019
View on TGA
State Implementation and Classification
Approved Date
05/07/2016
Field of Education
031309 - Communications Equipment Installation And Maintenance
Original Release Date
05/07/2016
Nominal Hours
35
Description
This unit describes the skills and knowledge required to modify a large size cable network or cut over new large size cables in the telecommunications access network. It includes telephony, data security and emergency services within the cable sheath.It applies to linesworkers, technicians or copper jointers working for carriers, contractors or other service providers who cut over and rearrange large size cable to distribution cabinets and housings. Work functions in the occupational areas where this unit may be used are subject to regulatory requirements. Refer to the Implementation Guide Companion Volume or the relevant regulator for specific guidance on requirements.
Notes
Elements and Performance Criteria
1. Prepare for cable modification and cutover
  • 1.1 Obtain relevant legislation, codes, client practices, regulations and standards for given work
  • 1.2 Obtain project plan from appropriate personnel and use it to scope work
  • 1.3 Arrange for site access according to local government and other authority requirements
  • 1.4 Inspect site to develop a work health and safety (WHS) plan and notify appropriate personnel of identified safety hazards
  • 1.5 Determine cable route and type of cable from project plan, and identify and avoid other services
  • 1.6 Determine large size cable handling and support facilities
  • 1.7 Obtain plant, tools, safety equipment and material to perform tasks safely and efficiently
  • 1.8 Prepare implementation plan with cutover tasks based on identified nature of job and seek client approval, if required
  • 1.9 Notify client and network carrier of proposed cutover details and proposed disruption to services
  • 1.10 Undertake additional preparatory non-jointing work, as required, according to client practices and site conditions
  • 1.11 Coordinate labour required for remote cutover of large size cable
2. Joint and cutover cable
  • 2.1 Follow WHS and environmental requirements for given work
  • 2.2 Notify appropriate personnel of cable pressure and equipment alarms
  • 2.3 Prepare joint enclosure and jointing cabinet for cutover cable entry, jointing activities and entry port enclosure sealing
  • 2.4 Set up jointing machines and jigs for jointing
  • 2.5 Joint cable according to jointing sequence, materials, joint type, location, and client practices and manufacturer’s guidelines and to meet service level agreements (SLAs)
  • 2.6 Test cable for performance and rectify any faults relating to cutover according to location, materials available and client practice
  • 2.7 Seal all joints according to cable type, location, and enterprise and manufacturer’s guidelines
3. Arrange cables and secure site
  • 3.1 Arrange cables in jointing chamber or cabinet according to client practices
  • 3.2 Recover obsolete materials and return to appropriate point for disposal
  • 3.3 Restore siteaccording to client practices and other authority requirements
4. Complete project documentation
  • 4.1 Complete reports on cutover installation, and design amendments to reflect existing cable layout, according to client practices
  • 4.2 Notify appropriate personnel of completion of cutover and obtain sign off
No information
No information
No information