Unit of competency Outline

Date retreived
22/07/2026 12:54 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Apply and trim decorative additions to shopfittings and components

Apply and trim decorative additions to shopfittings and components

Unit of competency
National Code
CPCSHP3005
State Code
OCM25
TGA Status
Current
DTWD Status
Approved
Current Release Number
2.00
Current Release Date
24/12/2024
View on TGA
State Implementation and Classification
Approved Date
01/06/2021
Field of Education
030113 - Cabinet Making
Original Release Date
01/06/2021
Nominal Hours
40
Description
This unit of competency specifies the skills and knowledge required to apply and trim specifically designed decorative panelling, frames, borders and mirrors to shopfittings and components to ensure a quality finish. It includes offsite work on units being fabricated for installation and on-site installation of units and internal walls.It applies to shopfitters who also work concurrently with clients and associated contractors to accommodate client requirements where the shop is operational.Individuals at this level take responsibility for organising and completing these tasks with a high degree of self-direction.No licensing, legislative or certification requirements apply to this unit of competency at the time of publication.Completion of the general construction induction training program, specified in the Safe Work Australia modelCode of Practice: Construction Work, is required by anyone carrying out construction work. Achievement of CPCWHS1001Prepare to work safely in the construction industrymeets this requirement.
Notes
Elements and Performance Criteria
1 Plan and prepare to apply decorative additions.
  • 1.1 Identify, read and interpret decorative additions from job requirements, plans and specifications.
  • 1.2 Determine type of decorative addition to be applied and calculate material quantities using measurements and formulas.
  • 1.3 Identify worksite hazards and conditions and implement risk control measures following work health and safety and environmental requirements.
  • 1.4 Determine job priorities and sequence job tasks in consultation with others in the workplace.
  • 1.5 Obtain materials, check for conformity and safely handle and locate materials ready for use.
  • 1.6 Establish appropriate method for fixing decorative additions to the substrate.
  • 1.7 Select, fit and use personal protective equipment (PPE) required for the task.
  • 1.8 Select tools and equipment for the task, check for serviceability, and rectify and report faults.
2 Fix and finish decorative additions.
  • 2.1 Set out position of decorative additions in accordance with plan and job description and confirm with client.
  • 2.2 Draw a plan to develop a true mitre for a compound angle and a mitre of different material widths and calculate angles by dissection.
  • 2.3 Set out, mark and cut to length decorative additions.
  • 2.4 Follow specifications to cut curved decorative additions work.
  • 2.5 Fit decorative additions and use established method to fix to substrate.
  • 2.6 Trim and finish decorative additions to meet organisational quality requirements.
3 Clean up.
  • 3.1 Clean tools and equipment, check for serviceability and report damage or faults.
  • 3.2 Clear work area and dispose of, reuse or recycle materials following workplace and environmental requirements.
  • 3.3 Store and secure tools and equipment following workplace procedures.
No information
No information
Replaces
State Code National Code Title Type
BBB02 CPCCSH3005 Apply and trim decorative additions to shopfittings and components Unit of competency