Unit of competency Outline

Date retreived
22/07/2026 8:41 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Diagnose faults in networked security systems

Diagnose faults in networked security systems

Unit of competency
National Code
CPPSEC4019
State Code
OBI68
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
30/09/2019
View on TGA
State Implementation and Classification
Approved Date
20/05/2020
Field of Education
029901 - Security Science
Original Release Date
20/05/2020
Nominal Hours
20
Description
This unit specifies the skills and knowledge required to diagnose faults in a range of security systems and networks. It includes applying methodical diagnostic procedures, testing suspected fault scenarios, and assessing test results, historical information and operational data to diagnose system and network faults and recommend options for rectification.This unit is suitable for those using specialised knowledge to complete routine and non-routine tasks and using their own judgement to deal with predictable and sometimes unpredictable problems.This unit may form part of the licensing requirements for people engaged in security risk management in those states and territories where these are regulated activities.
Notes
Elements and Performance Criteria
1 Prepare to diagnose security system or network faults.
  • 1.1 Access and interpret key requirements of legislation, regulations and workplace policies and procedures, including work health and safety (WHS), and apply to work instructions to ensure compliance.
  • 1.2 Review work instructions to confirm client requirements and work timeframes.
  • 1.3 Obtain and assess security system reports and clarify extent of faults in consultation with relevant persons.
  • 1.4 Review security system specifications and network configurations to confirm normal operational functions and performance parameters.
2 Plan and organise work tasks.
  • 2.1 Plan and prioritise work tasks allowing sufficient time to meet work instructions.
  • 2.2 Select and organise required materials, tools, testing devices and equipment including personal protective equipment and check for safe and correct operation.
  • 2.3 Arrange access to security system and network in consultation with relevant persons.
  • 2.4 Identify hazards in the work area and apply risk control measures.
3 Conduct system and network testing and diagnostic procedures.
  • 3.1 Use safe work practices when working with electronic equipment and cables according to WHS requirements.
  • 3.2 Isolate security equipment and system according to WHS requirements.
  • 3.3 Confirm normal performance of security equipment and system against specification schedules.
  • 3.4 Inspect and check security system components and test operation according to manufacturers’ instructions.
  • 3.5 Methodically apply diagnostic methods using measurements and estimations of system operating parameters and network configurations.
  • 3.6 Test suspected fault scenarios to identify source of system or network problems.
  • 3.7 Assess test data, site variables, operational and historical information to support fault diagnosis.
  • 3.8 Diagnose fault or seek assistance from relevant persons to meet work instructions.
4 Recommend options for fault rectification and complete documentation.
  • 4.1 Complete documentation detailing diagnosed faults and options for fault rectification supported by verifiable data according to workplace and regulatory requirements.
  • 4.2 Check tools and equipment for faults, wear or damage and rectify or report problems.
  • 4.3 Clean and restore work area and remove waste caused by work tasks.
No information
No information
Replaces
State Code National Code Title Type
D1469 CPPSEC4019A Identify and diagnose security system or network fault Unit of competency
State Code National Code Title Type
BEW9 CPP40719 Certificate IV in Security Management Qualification
BEW8 CPP41519 Certificate IV in Security Risk Analysis Qualification