Unit of competency Outline

Date retreived
22/07/2026 9:44 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Conduct non-destructive testing of wheel and rim assemblies

Conduct non-destructive testing of wheel and rim assemblies

Unit of competency
National Code
AURKTJ004
State Code
WI786
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
1.00
Current Release Date
10/01/2014
View on TGA
State Implementation and Classification
Approved Date
31/03/2014
Field of Education
030503 - Vehicle Mechanics
Original Release Date
31/03/2014
Nominal Hours
20
Description
This unit describes the performance outcomes required to conduct non-destructive testing of vehicle wheel and rim assemblies. It requires the ability to use technical skills to prepare for and conduct non-destructive testing.It applies to those who conduct non-destructive testing of vehicle wheels and rims in order to determine their serviceability by checking for material defects and malfunctions.Licensing, legislative, regulatory or certification requirements may apply to this unit in some jurisdictions. Users are advised to check with the relevant regulatory authority.
Notes
Elements and Performance Criteria
1. Prepare for non-destructive testing
  • 1.1 Workplace procedures and manufacturer instructions are used to determine job requirements
  • 1.2 Inspection area is cleaned and prepared for testing using workplace materials and in line with required procedures
  • 1.3 Tools and equipment are checked for safety and serviceability
  • 1.4 Non-destructive test equipment is prepared according to manufacturer instructions and workplace procedures
  • 1.5 Work area and equipment problems are reported to appropriate personnel
2. Perform non-destructive testing
  • 2.1 Testing methods are determined in line with workplace procedures and manufacturer specifications
  • 2.2 Hazards and safety requirements associated with testing are identified and addressed
  • 2.3 Testing is performed according to workplace procedures and manufacturer instructions
  • 2.4 Non-conformance and defects are identified against workplace procedures and manufacturer instructions
  • 2.5 Test results are verified and documented according to workplace procedures
3. Clean work area
  • 3.1 Testing equipment is maintained and stored according to workplace procedures
  • 3.2 Work area is cleaned and prepared for subsequent use
No information
No information
No information
State Code National Code Title Type
BAG5 AUR32616 Certificate III in Automotive Tyre Management Qualification