Unit of competency Outline

Date retreived
22/07/2026 4:41 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Fabricate and install external flashings

Fabricate and install external flashings

Unit of competency
National Code
CPCPRF3023
State Code
OCM96
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
27/11/2020
View on TGA
State Implementation and Classification
Approved Date
01/06/2021
Field of Education
030707 - Metal Fitting, Turning And MacHining
Original Release Date
01/06/2021
Nominal Hours
36
Description
This unit specifies the skills and knowledge required to fabricate and install external flashings. In some jurisdictions, this unit of competency may form part of accreditation, licensing, legislative, regulatory or certification requirements.
Notes
Elements and Performance Criteria
1 Prepare for work.
  • 1.1 Access, read and determine installation requirements and methods from relevant plans, specifications, current codes, Australian Standards and manufacturers’ instructions.
  • 1.2 Check that the materials used are compatible with the surrounding environment and other materials associated within the installation.
  • 1.3 Identify, interpret and follow workplace policies and procedures, work health and safety (WHS), environmental and sustainability requirements associated with the fabrication and installation of external flashings.
  • 1.4 Determine job priorities and sequence job tasks in consultation with others onsite.
  • 1.5 Identify potential hazards and determine and implement control measures and personal protective equipment (PPE) requirements.
  • 1.6 Check fall protection system is in place and secure.
  • 1.7 Select and check serviceability of appropriate tools, equipment and PPE.
2 Identify installation requirements.
  • 2.1 Locate external flashings to be installed from relevant working drawings, plans, specifications, site measurements, codes, Australian Standards and manufacturers’ instructions.
  • 2.2 Locate and select materials required for the installation.
  • 2.3 Order and receive required materials and equipment according to workplace requirements.
  • 2.4 Check materials and equipment against the docket and order form for correct product, compliance with Australian Standards and acceptable condition and action discrepancies according to workplace requirements.
3 Fabricate and install external flashings.
  • 3.1 Fabricate external flashings ensuring compliance with relevant working drawings, plans, specifications, site measurements, codes, Australian Standards and manufacturers’ instructions.
  • 3.2 Install external flashings using appropriate fastening and sealing methods.
4 Clean up.
  • 4.1 Clear the work area and dispose of, reuse or recycle materials in accordance with state or territory legislation and workplace requirements.
  • 4.2 Clean tools and equipment, check for serviceability and report any damage, and store and secure.
No information
No information
Replaces
State Code National Code Title Type
WF952 CPCPRF3023A Fabricate and install external flashings Unit of competency
State Code National Code Title Type
BGC2 CPC32420 Certificate III in Plumbing Qualification
BGD0 CPC32620 Certificate III in Roof Plumbing Qualification