Unit of competency Outline

Information current as of
19/10/2026 9:48 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Repair vehicle electrical faults in assembled vehicles

Repair vehicle electrical faults in assembled vehicles

Unit of competency
National Code
AUMATR001
State Code
WH923
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
1.00
Current Release Date
10/01/2014
View on TGA
State Implementation and Classification
Approved Date
11/03/2014
Original Release Date
10/01/2014
Nominal Hours
50
Field of Education
030505 - Automotive Electrics And Electronics
Description
This unit describes the performance outcomes required to repair electrical faults in assembled vehicles, based on recommendations from inspection reports.It applies to those in an automotive manufacturing environment and involves the application of skills and knowledge at a specialist technician level.No licensing, legislative or certification requirements apply to this unit at the time of publication.
General notes
N/A
Elements and Performance Criteria
1. Plan and prepare
  • 1.1 Workplace instructions are identified and used to determine job requirements
  • 1.2 Repair procedures and fault inspection reports are sourced and interpreted
  • 1.3 Repair and replacement materials are identified, obtained and prepared according to inspection reports
  • 1.4 Tools and equipment are identified for rectification of electrical faults
2. Diagnose and rectify electrical faults
  • 2.1 Faults are located and diagnosed, and corrective repairs are planned
  • 2.2 Rectification activities are carried out according to vehicle specifications and workplace procedures
  • 2.3 Faults are re-diagnosed to ensure their elimination
3. Complete work processes
  • 3.1 Repair documentation is completed according to workplace procedures
  • 3.2 Final inspection is made to ensure work is to workplace quality standards
  • 3.3 Tools and equipment are cleaned, checked, maintained and stored, and work area is cleaned, according to workplace procedures
  • 3.4 Faulty tools and equipment are identified, tagged and reported to supervisor
  • 3.5 Work area is cleaned, and materials disposed of, reused or recycled according to workplace procedures
No information
No information
No information