Unit of competency Outline

Date retreived
22/07/2026 6:17 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Construct masonry steps and stairs

Construct masonry steps and stairs

Unit of competency
National Code
CPCCBL3004
State Code
OCO92
TGA Status
Current
DTWD Status
Approved
Current Release Number
2.00
Current Release Date
24/12/2024
View on TGA
State Implementation and Classification
Approved Date
01/06/2021
Field of Education
040309 - Bricklaying And Stonemasonry
Original Release Date
01/06/2021
Nominal Hours
32
Description
This unit specifies the skills and knowledge required to calculate and construct masonry steps, stairs and wing walls using various masonry products. This unit applies to bricklayers and blocklayers who set out and construct steps and stairs on new or existing structures. It is suitable for people operating with some autonomy. A person working at this level would be expected to take responsibility for organising and completing tasks assigned to them without needing close supervision.Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001Prepare to work safely in the construction industrymeets this requirement. No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Prepare for work.
  • 1.1 Select, fit correctly and use personal protective equipment (PPE) appropriate for job.
  • 1.2 Read, interpret and apply masonry steps and stairs requirements from current plans, specifications, standards and codes.
  • 1.3 Follow requirements in workplace safety and environmental documentation and workplace procedures.
  • 1.4 Calculate material quantities for the task.
  • 1.5 Identify potential hazards and determine and implement control measures.
  • 1.6 Select and check condition of plant, equipment and tools and report damage or faults to relevant person.
  • 1.7 Check conformity of materials against the specifications, blend masonry products and place materials in preparation for the work.
2 Set out brickwork/blockwork.
  • 2.1 Calculate the total rise and going of the flight of stairs.
  • 2.2 Calculate tread, riser sizes and slope relationship rule.
  • 2.3 Set out position of stairs on a prepared footing to comply with plans, specifications and Australian Standards.
  • 2.4 Set out parallel wing wall to maintain bond and gauge with treads and risers.
3 Lay steps and wing walls.
  • 3.1 Mix mortar to consistency for job requirements.
  • 3.2 Construct base brickwork or blockwork accurately to set out marks.
  • 3.3 Lay stairs square and plumb to the specified bond.
  • 3.4 Construct parallel sloping wing wall to align with tread and riser bond and gauge.
  • 3.5 Finish joints to specified profile.
  • 3.6 Brush down face of brickwork/blockwork prior to drying to remove unwanted mortar.
4 Clean up.
  • 4.1 Clear the work area, and dispose, reuse or recycle materials following workplace and environmental requirements.
  • 4.2 Clean tools and equipment, check for serviceability and report damage or faults.
  • 4.3 Store and secure tools and equipment following workplace procedures.
No information
No information
Replaces
State Code National Code Title Type
W9323 CPCCBL3004A Construct masonry steps and stairs Unit of competency
State Code National Code Title Type
BGD8 CPC33020 Certificate III in Bricklaying and Blocklaying Qualification