Unit of competency Outline

Date retreived
22/07/2026 10:32 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Fit upholstery components

Fit upholstery components

Unit of competency
National Code
MSFUP2002
State Code
WI662
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
030115 - Furniture Upholstery And Renovation
Original Release Date
19/06/2014
Nominal Hours
36
Description
This unit of competency covers fitting upholstery components ready to assemble upholstered furniture.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Prepare for component application
  • 1.1 Work instructions are used determine job requirements including design variations, tolerances, process, materials, finish and quality
  • 1.2 Components to be fitted are identified
  • 1.3 Fitting sequence is determined
  • 1.4 Procedures are determined for checking the quality at each stage of the process
  • 1.5 Work health and safety (WHS) requirements, including personal protection needs, are observed throughout the work
  • 1.6 Fixing devices are selected in accordance with work instructions and the type of materials to be used
  • 1.7 Suitable work area is selected for the task
  • 1.8 Components, materials, fittings and attachments are collected
  • 1.9 Tools and equipment suitable to the applicable fitting methods are selected and checked for safe operation
2 Fit components
  • 2.1 Components are laid out and attached using appropriate fastenings
  • 2.1 Hand and power tools and equipment are used, as required
  • 2.3 Attached components are checked for compliance with specifications
  • 2.4 Products which do not meet quality specifications are repaired or tagged for further processing or recycling/disposal in accordance with workplace practices
  • 2.5 Finished products are organised and stored in holding area to enterprise requirements
3 Complete work
  • 3.1 Faulty and/or defective equipment is tagged and reported in accordance with workplace procedures
  • 3.2 Waste and scrap are removed in accordance with workplace procedures
  • 3.3 Tools and equipment used are cleaned, inspected for serviceable condition and stored appropriately in accordance with workplace procedures
  • 3.4 Equipment is maintained and work area cleaned in accordance with workplace procedures
No information
No information
Replaces
State Code National Code Title Type
W8806 LMFUP2002B Fit upholstery components Unit of competency
Replaced By
State Code National Code Title Type
OEK75 MSFUP2008 Fit upholstery components Unit of competency
State Code National Code Title Type
J725 MSF20113 Certificate II in Furnishing Qualification
J735 MSF30713 Certificate III in Upholstery Qualification