Unit of competency Outline

Date retreived
22/07/2026 5:07 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Hand mould products

Hand mould products

Unit of competency
National Code
MSMPMC310
State Code
OAF83
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
22/10/2018
View on TGA
State Implementation and Classification
Approved Date
21/05/2019
Field of Education
100305 - Crafts
Original Release Date
21/05/2019
Nominal Hours
30
Description
This unit describes the skills and knowledge required to hand mould products using clay, ceramic, plaster and other materials. This unit applies to operators who are required to take responsibility for own outputs and follow established procedures to select and prepare the moulds and then mould, remove, finish and store the product. Operators are also required to work autonomously and apply their own judgement to interpret information; monitor processes; identify and address routine and non-routine problems and control hazards. This unit applies to an individual working alone or as part of a team or group and in liaison with other shift team members, team leader and supervisor. No licensing or certification requirements exist at the time of publication. Relevant legislation, industry standards and codes of practice within Australia must be applied.
Notes
Elements and Performance Criteria
1. Assemble and prepare the mould or former
  • 1.1 Establish and maintain a safe working environment according to procedures
  • 1.2 Identify and prepare appropriate mould or former
  • 1.3 Level and secure the mould or former
  • 1.4 Check that the base is stabilised and correctly mounted as required to facilitate rolling or turning out
  • 1.5 Position inserts or loose pieces
  • 1.6 Apply the correct stripping agent
2. Mould materials
  • 2.1 Prepare the material mix or obtain the material from the batch preparation unit according to specifications
  • 2.2 Provide an adequate supply of material to meet production requirements
  • 2.3 Introduce material to the work piece cavity and compact according to procedures
  • 2.4 Check inserts or loose pieces and secure to avoid movement during moulding
  • 2.5 Roll and strip or turn out the component for finishing
3. Finish the component or product
  • 3.1 Repair defects occurring during the moulding process
  • 3.2 Remove inserts or loose pieces and replace in mould or former
  • 3.3 Prepare the surface of the component for the application of any surface finishes
  • 3.4 Cure or dry the components to specification
  • 3.5 Return mould and/or segments for re-use or storage
4. Inspect and store components
  • 4.1 Inspect component for defects
  • 4.2 Store the component to specifications and procedures
5. Rectify routine problems
  • 5.1 Identify and rectify faults and equipment failure
  • 5.2 Maintain records and log books of equipment operations
  • 5.3 Identify non-routine problems and report to designated person
6. Identify hazards
  • 6.1 Identify hand moulding hazards
  • 6.2 Implement hazard controls according to procedures
  • 6.3 Report safety concerns according to procedures
No information
No information
Replaces
State Code National Code Title Type
BAH61 PMC552024 Hand mould products Unit of competency