Unit of competency Outline

Date retreived
22/07/2026 10:31 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Perform basic eddy current testing

Perform basic eddy current testing

Unit of competency
National Code
MEM18112
State Code
OFH49
TGA Status
Current
DTWD Status
Pending
Current Release Number
1.00
Current Release Date
04/09/2025
View on TGA
State Implementation and Classification
Approved Date
Field of Education
030305 - Materials Engineering
Original Release Date
Nominal Hours
Description
This unit of competency defines the skills and knowledge required to operate eddy current testing equipment and the preparation and performance of eddy current testing on fabrications, structures and components across a wide range of industries.Eddy current testing is performed on critical component or structural zones. Actual and potential defects are considered, together with ongoing abnormalities.This unit should not be selected when unit MEM24026 Undertake eddy current tests has already been selected.Where interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.Where the selection and use of engineering measurements is required unit MEM12023 Perform engineering measurements should also be selected.Where the selection and use of power tools are required unit MEM18002 Use power tools/hand held operations should also be selected.Band: AUnit Weight: 2Assessment as competent against MEM18112 Perform basic eddy current testing may contribute to certification against Australian Standards where assessment in this unit of competency is carried out in conjunction with an examining authority as described in AS ISO 9712 NDT - Qualification and certification of NDT personnel or subsequent Standards.
Notes
Elements and Performance Criteria
1. Determine job requirements
  • 1.1 Follow standard operating procedures (SOPs)
  • 1.2 Comply with work health and safety (WHS) requirements at all times
  • 1.3 Use appropriate personal protective equipment (PPE) in accordance with SOPs
  • 1.4 Identify job requirements from specifications
2. Prepare inspection areas for basic eddy current testing
  • 2.1 Clean inspection areas and prepare for testing using appropriate procedures and materials
  • 2.2 Carry out preparation processes in accordance with the relevant procedures
  • 2.3 Assess inspection areas visually and identify obvious discontinuities
3. Perform basic tests
  • 3.1 Identify nominated test from SOPs
  • 3.2 Prepare test equipment in accordance with standards and/or procedures
  • 3.3 Carry out eddy current test procedure in accordance with relevant work instructions
  • 3.4 Maintain eddy current test equipment and store in accordance with SOPs
4. Report the results of basic eddy current tests
  • 4.1 Check and confirm basic indications and identify defects in accordance with organisational standards and/or procedures
  • 4.2 Report test results in accordance with organisational standards and/or procedures
No information
No information
Replaces
State Code National Code Title Type
OEU10 MEM24005 Perform basic eddy current testing Unit of competency
State Code National Code Title Type
BEL1 MEM30219 Certificate III in Engineering - Mechanical Trade Qualification