Unit of competency Outline

Date retreived
22/07/2026 11:30 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Cut panels

Cut panels

Unit of competency
National Code
FWPWPP2201
State Code
AXJ51
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
13/05/2016
View on TGA
State Implementation and Classification
Approved Date
05/10/2016
Field of Education
030111 - Wood MacHining And Turning
Original Release Date
05/10/2016
Nominal Hours
20
Description
This unit of competency describes the outcomes required to cut panels to size with a power driven saw. Work is completed in a forest products factory setting and includes operator maintenance.The unit applies to production workers who cut panels in a forest and wood products factory setting and includes operator maintenance.No licensing, legislative, regulatory, or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for cutting
  • 1.1 Review work order and where required check with appropriate personnel.
  • 1.2 Obtain type and quantity of material to be cut from storage location.
  • 1.3 Select appropriate personal protective and other equipment and check for operational effectiveness.
  • 1.4 Plan material cutting patterns and saw set-up sequences in line with work order.
2. Cut material to size or angle
  • 2.1 Use equipment in line with organisational safety procedures, manufacturer’s instructions and environmental protection practices.
  • 2.2 Mark up material and set stops in preparation for cutting.
  • 2.3 Follow cutting sequence and patterns to produce required quantity.
  • 2.4 Check cuts for length and angle within set tolerances.
  • 2.5 Dispose of incorrect cuts, off cuts and defective material in line with environmental protection practices.
  • 2.6 Stack material safely in designated location in line with work order.
3. Complete operator maintenance
  • 3.1 Follow organisational safety procedures to lock out equipment.
  • 3.2 Check saw blades for bluntness or damage.
  • 3.3 Remove and replace saw blades in line with manufacturer's recommendations.
  • 3.4 Dispose of used blades in line with environmental protection practices.
  • 3.5 Keep machine clear of dust and debris in line with organisational safety procedures.
  • 3.6 Record and report production outcomes, equipment faults and maintenance requirements to appropriate personnel.
No information
No information
Replaces
State Code National Code Title Type
D6105 FPIWPP2201B Cut panels Unit of competency
Replaced By
State Code National Code Title Type
OCR30 FWPWPP2213 Cut panels Unit of competency