Unit of competency Outline

Date retreived
22/07/2026 4:01 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Perform basic tests

Perform basic tests

Unit of competency
National Code
MSL973025
State Code
OEX92
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
20/12/2022
View on TGA
State Implementation and Classification
Approved Date
24/05/2023
Field of Education
019909 - Laboratory Technology
Original Release Date
24/05/2023
Nominal Hours
80
Description
This unit of competency describes the skills and knowledge to prepare samples and perform tests and measurements using standard methods with access to readily available advice from supervisors. This unit of competency applies to laboratory/field assistants working in all industry sectors. In general, they do not calibrate equipment and make only limited adjustments to the controls. They do not interpret or analyse results or troubleshoot equipment problems.No licensing or certification requirements exist at the time of publication. However, regulations and/or external accreditation requirements for laboratory operations exist, so local requirements should be checked. Relevant legislation, industry standards and codes of practice within Australia must also be applied.
Notes
Elements and Performance Criteria
1. Interpret test requirements
  • 1.1 Review test request to identify samples to be tested, test method and equipment involved
  • 1.2 Identify hazards and workplace controls associated with the sample, preparation methods, reagents and/or equipment
2. Prepare sample
  • 2.1 Match sample provided to accompanying documentation and report any discrepancies in accordance with workplace procedures
  • 2.2 Prepare sample in accordance with workplace procedures
3. Check equipment before use
  • 3.1 Set up test equipment in accordance with test method
  • 3.2 Perform pre-use and safety checks in accordance with workplace procedures and manufacturer instructions
  • 3.3 Identify faulty or unsafe equipment and report to appropriate personnel
  • 3.4 Check calibration status of equipment and report any out-of-calibration items to appropriate personnel
4. Perform tests on samples
  • 4.1 Identify, prepare and weigh or measure sample and standards to be tested
  • 4.2 Conduct tests in accordance with workplace procedures
  • 4.3 Record data in accordance with workplace procedures
  • 4.4 Perform any required calculations on data
  • 4.5 Identify and report out of specification or atypical results promptly to appropriate personnel
  • 4.6 Shut down equipment in accordance with operating procedures
5. Maintain a safe work environment
  • 5.1 Use established safe work practices and personal protective equipment (PPE) to ensure personal safety and that of other laboratory personnel
  • 5.2 Minimise the generation of wastes and environmental impacts
  • 5.3 Ensure safe disposal of laboratory and hazardous wastes
  • 5.4 Clean, care for and store equipment and reagents in accordance with workplace procedures
No information
No information
Replaces
State Code National Code Title Type
OAC76 MSL973013 Perform basic tests Unit of competency