Unit of competency Outline

Date retreived
22/07/2026 12:00 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Blend and test binding mixes

Blend and test binding mixes

Unit of competency
National Code
FWPWPP3219
State Code
AXJ23
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
2.00
Current Release Date
18/12/2018
View on TGA
State Implementation and Classification
Approved Date
05/10/2016
Field of Education
030305 - Materials Engineering
Original Release Date
05/10/2016
Nominal Hours
20
Description
This unit of competency describes the skills and knowledge required to blend and test binding mixes used in the production of engineered wood panels. The unit applies to individuals who work as production operators and technicians in an engineered wood panel facility. Operators generally work under broad or limited direction to complete routine activities related to their own work, and take responsibility for their work.All work must be carried out to comply with workplace procedures, according to state/territory health and safety regulations, legislation and standards that apply to the workplace.No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for blending binding mix
  • 1.1 Review work order, workplace health and safety requirements, environmental protection practices and emergency procedures for blending binding mix and, where required, check with appropriate personnel
  • 1.2 Identify and report hazards and use personal protective equipment according to workplace requirements and health and safety legislation to maintain safe work practices
  • 1.3 Obtain the type and quantity of binding mix for blending from storage
  • 1.4 Select and plan blending process according to work order
2. Set up equipment and blend binding mix
  • 2.1 Use equipment according to workplace health and safety procedures, manufacturer instructions and environmental protection practices
  • 2.2 Set blend cycles according to work order
  • 2.3 Measure ingredients and additives and blend to ensure minimum wastage
  • 2.4 Transfer blend to appropriate storage location or production equipment through transfer lines without contamination
  • 2.5 Monitor rate of including additives and, where required, adjust pumps
3. Test binding mix results
  • 3.1 Test blend samples regularly, checking tack and adhesion properties
  • 3.2 Interpret test results and, where required, adjust blend to achieve desired properties
  • 3.3 Reject and dispose of incorrect blend according to environmental protection practices
4. Maintain and clean equipment
  • 4.1 Clean blending, storage and transfer equipment according to workplace health and safety procedures
  • 4.2 Turn off pumps and flush equipment according to manufacturer instructions
  • 4.3 Dispose of excess blended material and additives according to environmental protection practices
  • 4.4 Store equipment and ingredients according to workplace health and safety procedures
  • 4.5 Record and report production outcomes and equipment faults to appropriate personnel
No information
No information
Replaces
State Code National Code Title Type
D6134 FPIWPP3219B Blend and test binding mixes Unit of competency
State Code National Code Title Type
BAL3 FWP30416 Certificate III in Wood Panel Products Qualification