Unit of competency Outline

Information current as of
21/10/2026 8:59 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Perform die coating

Perform die coating

Unit of competency
National Code
AUMFTA002
State Code
WH936
TGA Status
Deleted
DTWD Status
Deleted
Current Release Number
1.00
Current Release Date
10/01/2014
View on TGA
State Implementation and Classification
Approved Date
11/03/2014
Original Release Date
10/01/2014
Nominal Hours
30
Field of Education
030713 - Metal Casting And Patternmaking
Description
This unit describes the performance outcomes required to coat dies for their later use in casting processes.It applies to those in an automotive and related component manufacturing environment and involves the application of skills and knowledge at a specialist level.No licensing, legislative or certification requirements apply to this unit at the time of publication.
General notes
N/A
Elements and Performance Criteria
1. Plan and prepare
  • 1.1 Job instructions and quality requirements are identified and confirmed with appropriate personnel
  • 1.2 Tools and equipment required for the job are selected and checked for faults and correct operation
  • 1.3 Materials required to complete the job are identified and prepared
2. Disassemble and inspect dies
  • 2.1 Die is safely located in the coating area
  • 2.2 Die coating insulation materials are inspected for wear, and removed if required
  • 2.3 Dies are inspected and analysed for defects, and identified defects are rectified according to workplace procedures
  • 2.4 Dies are tested to ensure rectification has eliminated the fault, and adjustments are made if required
3. Coat and assemble dies
  • 3.1 Die coating insulation material is selected and prepared according to workplace procedures
  • 3.2 Die is cleaned in preparation for coating and heated according to workplace and equipment manufacturer recommendations and work health and safety (WHS) requirements
  • 3.3 Die coating insulation material is applied to the die, and die is assembled and checked in preparation for pressing according to workplace and equipment manufacturer recommendations
  • 3.4 Die is returned to production sequence
4. Complete work processes
  • 4.1 Work area is cleaned, and materials disposed of or recycled according to workplace procedures
  • 4.2 Tools and equipment are cleaned, checked, maintained and stored according to workplace procedures
  • 4.3 Documentation is completed according to workplace procedures
No information
No information
No information