Unit of competency Outline

Date retreived
22/07/2026 2:54 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Perform microscopic examination

Perform microscopic examination

Unit of competency
National Code
MSL973028
State Code
OEX89
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
20/12/2022
View on TGA
State Implementation and Classification
Approved Date
24/05/2023
Field of Education
019909 - Laboratory Technology
Original Release Date
24/05/2023
Nominal Hours
40
Description
This unit of competency describes the skills and knowledge to set up a light microscope for optimum resolution, to prepare routine samples and to observe, identify and report sample characteristics. This unit of competency applies to laboratory assistants and technicians in all industry sectors. The unit of competency covers limited interpretation and analysis of results. Troubleshooting of equipment and procedures is not required.No licensing or certification requirements exist at the time of publication. However, regulations and/or external accreditation requirements for laboratory operations exist, so local requirements should be checked. Relevant legislation, industry standards and codes of practice within Australia must also be applied.
Notes
Elements and Performance Criteria
1. Prepare samples for examination
  • 1.1 Use personal protective equipment (PPE) to ensure safety and minimise cross-contamination?
  • 1.2 Prepare samples for microscopic examination in accordance with workplace procedures
2. Set up and use a light microscope
  • 2.1 Carry and use a microscope correctly, preventing damage to the equipment and ensuring operator safety
  • 2.2 Perform pre-use and safety checks to ensure equipment is fit for purpose
  • 2.3 Check external lenses to ensure they are clean
  • 2.4 Set up the microscope for optimum resolution and even illumination
  • 2.5 Select the appropriate objectives and filter for the sample being examined
  • 2.6 Place sample correctly on the stage
3. Observe and identify sample characteristics
  • 3.1 Recognise and identify significant sample characteristics
  • 3.2 Perform required counts and measurements
  • 3.3 Collect and dispose of all wastes safely
No information
No information
Replaces
State Code National Code Title Type
OAC81 MSL973019 Perform microscopic examination Unit of competency