Unit of competency Outline

Date retreived
23/07/2026 7:22 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Mount artwork

Mount artwork

Unit of competency
National Code
MSFPF2011
State Code
OAI46
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
03/12/2018
View on TGA
State Implementation and Classification
Approved Date
22/05/2019
Field of Education
030199 - Manufacturing Engineering And Technology, N.e.c.
Original Release Date
22/05/2019
Nominal Hours
52
Description
This unit describes the skills and knowledge required to mount artwork to substrates prior to framing. It includes dry and wet mounting, pressure rolling, laminating and hinging of artwork. Frames may be for artworks, documents, textiles or three dimensional (3D) items.This unit applies to picture framers completing work according to a pre-determined frame design. No licensing or certification requirements exist at the time of publication. Relevant legislation, industry standards and codes of practice within Australia must be applied.
Notes
Elements and Performance Criteria
1. Prepare for work
  • 1.1 Read work order and identify mounting requirements
  • 1.2 Assess artwork to determine the most appropriate mounting process, including the composition of substrate and fixing materials
  • 1.3 Identify and observe quality assurance requirements are identified and observed throughout the process in accordance with industry standards and workplace practices
  • 1.4 Identify and follow work health and safety requirements throughout the work
  • 1.5 Select tools and equipment suited to the type of mounting and check for quality, serviceability and safety prior to use
  • 1.6 Accurately measure and cut materials to size, and assemble in accordance with industry standards and workplace procedures
  • 1.7 Position fixing agents in accordance with workplace procedures
2. Mount artwork to substrate
  • 2.1 Set up mounting equipment in accordance with manufacturer instructions and workplace practices
  • 2.2 Position artwork in accordance with job requirements
  • 2.3 Prepare and apply required adhesives based on type and composition of artwork
  • 2.4 Operate mounting equipment safely and in accordance with manufacturer instructions
  • 2.5 Inspect mounted artwork for compliance with quality and work order requirements and rectify any deficiencies
3. Complete work
  • 3.1 Mark completed work for identification and store in accordance with workplace procedures
  • 3.2 Identify and store items for recycling in accordance with workplace procedures
  • 3.3 Clean work area and safely dispose of rubbish
  • 3.4 Accurately complete required workplace documentation
  • 3.5 Check, clean and store tools and equipment in accordance with workplace procedures
No information
No information
Replaces
State Code National Code Title Type
WI583 MSFPF2004 Mount artwork Unit of competency
State Code National Code Title Type
J725 MSF20113 Certificate II in Furnishing Qualification
BIJ6 MSF20122 Certificate II in Furnishing Qualification
BED4 MSF30518 Certificate III in Picture Framing Qualification