Unit of competency Outline

Date retreived
22/07/2026 7:12 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Assemble furnishing components

Assemble furnishing components

Unit of competency
National Code
MSFFM2002
State Code
WI411
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
030113 - Cabinet Making
Original Release Date
19/06/2014
Nominal Hours
24
Description
This unit of competency covers assembling of timber components to produce furniture frames or furniture.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Prepare for assembly
  • 1.1 Work instructions are used to determine job requirements, including design, tolerances, process, materials, finish and quantity
  • 1.2 Assembly sequence is planned
  • 1.3 Procedures are determined for checking quality at each stage of the process
  • 1.4 Work health and safety (WHS) requirements, including personal protection needs, are observed throughout the work
  • 1.5 Suitable work area is selected for the task
  • 1.6 Tools and equipment suitable to the fixing method are selected and checked for safe operation
  • 1.7 Components, hardware, fittings and attachments are collected
  • 1.8 Fixing and joining devices are selected in line with work instructions and type of materials to be joined
  • 1.9 Jigs are selected and checked for suitability of purpose
2 Assemble components
  • 2.1 Components are laid out and joined using jigs and appropriate fastenings
  • 2.2 Hand and/or power tools and equipment are used as required
  • 2.3 Components are prepared, assembled and fitted in accordance with specifications
  • 2.4 Assembled component is checked for compliance with specifications
  • 2.5 Components which do not meet quality specifications are repaired or tagged for further processing or recycling/disposal
  • 2.6 Finished products are organised and stored in holding area
3 Clean work area and maintain equipment
  • 3.1 Faulty and/or defective equipment is tagged and reported in accordance with workplace procedures
  • 3.2 Waste and scrap are removed following workplace procedures
  • 3.3 Tools and equipment used are cleaned, inspected for serviceable condition and stored appropriately in accordance with workplace procedures
  • 3.4 Equipment and work area clean-up is maintained in accordance with workplace procedures
No information
No information
Replaces
State Code National Code Title Type
W8600 LMFFM2002B Assemble furnishing components Unit of competency
Replaced By
State Code National Code Title Type
OEL19 MSFFM2019 Assemble furnishing products Unit of competency