Unit of competency Outline

Date retreived
22/07/2026 7:47 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Prepare surfaces for signs

Prepare surfaces for signs

Unit of competency
National Code
CPCCSG3016
State Code
BBB07
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
09/09/2016
View on TGA
State Implementation and Classification
Approved Date
23/01/2017
Field of Education
040325 - Painting, Decorating And Sign Writing
Original Release Date
23/01/2017
Nominal Hours
16
Description
This unit of competency specifies the outcomes required to ensure surfaces are prepared and ready for fixing signs. The unit covers assessing surfaces, which can include metals, plastics, brick and plasterboard walls; identifying the extent of preparation required; selecting and preparing equipment; and applying materials to the surface safely and effectively, minimising damage to surrounding areas. The unit supports sign manufacturers who install signs in a range of indoor and outdoor settings.No licensing, legislative, regulatory or certification requirements apply to this unit of competency at the time of endorsement.
Notes
Elements and Performance Criteria
1 Plan surface preparation.
  • 1.1 Job requirements, including type of surface, are identified from drawings, specifications and instructions and type, and confirmed.
  • 1.2 Health and safety requirements are assessed and applied to planning.
  • 1.3 Tools, equipment, paint systems and materials are selected to carry out tasks consistent with job requirements, and faults are rectified or reported before starting work.
  • 1.4 Drop sheets are placed if required to protect floor and surrounding areas.
  • 1.5 Personal protective equipment (PPE) is sourced according to manufacturer specifications, and health and safety and workplace requirements.
  • 1.6 Signs and barricades are selected and installed according to health and safety and workplace requirements.
2 Clean and prime surface.
  • 2.1 Condition of surface is assessed.
  • 2.2 Surface is roughly sanded according to job requirements.
  • 2.3 Surface is cleaned to remove grease and dirt and allowed to dry.
  • 2.4 Undercoat is applied to surface and allowed to dry according to manufacturer specifications.
  • 2.5 Primer is applied to surface and allowed to dry according to manufacturer specifications.
3 Apply paint.
  • 3.1 Paint applicator compatible with coating type is selected and prepared according to manufacturer specifications.
  • 3.2 Spray gun and air compressor, if required, are set to manufacturer specifications and correct viscosity of paint is determined for specified application.
  • 3.3 Coating is applied evenly over the surface area and defects in application are identified and rectified.
4 Clean up.
  • 4.1 Paint applicator is cleaned using correct cleaning products and according to workplace procedures and manufacturer specifications.
  • 4.2 Surface and surrounding work area are cleaned using correct solvents and in line with safety and environmental requirements.
  • 4.3 Waste materials are handled and removed according to statutory and regulatory authority requirements.
  • 4.4 Tools and equipment, including personal protective equipment (PPE), are cleaned, maintained and stored according to workplace requirements.
No information
No information
Replaces
State Code National Code Title Type
W9522 CPCCSI2003A Prepare surfaces for signage Unit of competency
State Code National Code Title Type
BDJ3 CPC30216 Certificate III in Signs and Graphics Qualification