Unit of competency Outline

Date retreived
22/07/2026 12:46 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Cut using oxy-acetylene equipment

Cut using oxy-acetylene equipment

Unit of competency
National Code
CPCPCM2049
State Code
OCO81
TGA Status
Current
DTWD Status
Approved
Current Release Number
2.00
Current Release Date
23/12/2020
View on TGA
State Implementation and Classification
Approved Date
01/06/2021
Field of Education
030711 - Boilermaking And Welding
Original Release Date
01/06/2021
Nominal Hours
8
Description
This unit specifies the skills and knowledge required to use oxy-acetylene equipment to carry out basic cutting of mild steel.In some jurisdictions, this unit of competency may form part of accreditation, licensing, legislative, regulatory or certification requirements.
Notes
Elements and Performance Criteria
1 Identify cutting requirements.
  • 1.1 Access, read and determine cutting requirements from relevant job plans and specifications, codes, Australian standards, manufacturer’s specifications and jurisdictional requirements.
  • 1.2 Identify and apply workplace, work health and safety (WHS) and environmental requirements.
2 Prepare for work.
  • 2.1 Create a materials list and collect materials.
  • 2.2 Select appropriate tools and equipment, including personal protective equipment (PPE).
  • 2.3 Prepare work area to support efficient cutting with oxy-acetylene equipment.
3 Perform cuts and inspect.
  • 3.1 Set up oxy-acetylene cutting equipment according to relevant codes, Australian standards, manufacturer's specifications and jurisdictional requirements.
  • 3.2 Select tip size appropriate for the materials to be cut.
  • 3.3 Adjust cutting pressures to manufacturer recommendations for the materials to be cut.
  • 3.4 Prepare materials for cutting according to relevant job plans and specification, codes, Australian standards, manufacturer’s specifications and jurisdictional requirements.
  • 3.5 Mark out materials prior to cutting.
  • 3.6 Set flame and perform cuts according to the specified cutting procedures to affect a clean cut.
  • 3.7 Visually inspect completed cuts for compliance with relevant job plans and specifications.
4 Clean up.
  • 4.1 Clear the work area, and dispose of, reuse or recycle materials in accordance with state and territory legislation and workplace policies and procedures.
  • 4.2 Clean tools and equipment, check for serviceability and report any damage, and store and secure.
No information
No information
Replaces
State Code National Code Title Type
WF838 CPCPCM2049A Cut using oxy-LPG-acetylene equipment Unit of competency