Unit of competency Outline

Date retreived
23/07/2026 7:21 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Repair springs

Repair springs

Unit of competency
National Code
MEM06006
State Code
OAW57
TGA Status
Replaced
DTWD Status
Transition (Replaced)
Current Release Number
1.00
Current Release Date
26/06/2019
View on TGA
State Implementation and Classification
Approved Date
18/04/2021
Field of Education
030799 - Mechanical And Industrial Engineering And Technology, N.e.c.
Original Release Date
18/04/2021
Nominal Hours
36
Description
This unit of competency defines the skills and knowledge required to assess spring condition, set and reset springs for repair, set up and operate spring forming equipment, form and shape material and test components.Equipment use does not include automated spring making equipment.Where the interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.Where the selection and use of engineering measurement is required unit MEM12023 Perform engineering measurements should also be selected.Where the selection and use of power tools/hand held operations is required unit MEM18002 Use power tools/hand held operations should also be selected.No licensing, legislative or certification requirements apply to this unit at the time of publication.Band: AUnit Weight: 4
Notes
Elements and Performance Criteria
1 Determine job requirements
  • 1.1 Follow standard operating procedures (SOPs)
  • 1.2 Comply with work health and safety (WHS) requirements at all times
  • 1.3 Use appropriate personal protective equipment (PPE) in accordance with SOPs
  • 1.4 Identify job requirements from specifications, sketches, job sheets or work instructions
2 Assess spring condition
  • 2.1 Check springs for correct operation and identify defects in accordance with SOPs
  • 2.2 Identify springs suitable for rework and the appropriate repair procedure
3 Set and reset springs for repair
  • 3.1 Apply correct stripping procedure
  • 3.2 Allow for setting tolerances in set/reset of springs to specification
  • 3.3 Control correct temperature for setting/resetting springs
4 Set up and operate spring forming equipment
  • 4.1 Set up and use equipment in accordance with procedures
  • 4.2 Position spring material and safety guards
  • 4.3 Select forming equipment and tools for given application
5 Form and shape material
  • 5.1 Determine material lengths
  • 5.2 Taper, roll and bend material to conform to specifications
  • 5.3 Adopt correct procedure for hot and cold forming
  • 5.4 Make allowance for relief and spring-back
6 Test components
  • 6.1 Determine spring compression from specifications
  • 6.2 Determine any defects and confirm dimensional accuracy
  • 6.3 Re-set non-conforming springs and adjust spring forming equipment as necessary
  • 6.4 Nest springs to specification
No information
No information
Replaces
State Code National Code Title Type
W5351 MEM06006C Repair springs Unit of competency
Replaced By
State Code National Code Title Type
OFH24 MEM06013 Repair springs Unit of competency