Unit of competency Outline

Date retreived
23/07/2026 4:41 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Fabricate and install automotive and marine frames, canopies and side curtains

Fabricate and install automotive and marine frames, canopies and side curtains

Unit of competency
National Code
AURVTT019
State Code
AWZ02
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
14/04/2016
View on TGA
State Implementation and Classification
Approved Date
13/07/2016
Field of Education
030513 - Upholstery And Vehicle Trimming
Original Release Date
13/07/2016
Nominal Hours
30
Description
This unit describes the performance outcomes required to measure, mark out and cut, fabricate and install automotive and marine frames, canopies and side curtains to manufacturer specifications and customer instructions. It involves preparing for the task, selecting and using specialist tools and equipment, selecting materials and checking their quality, and completing workplace processes and documentation.It applies to those working in the automotive and marine trimming industry.No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for fabrication
  • 1.1 Job requirements are determined from workplace instructions
  • 1.2 Frame, components and materials are selected and inspected for quality
  • 1.3 Hazards associated with the work are identified and risks are managed
  • 1.4 Tools and equipment, including personal protective equipment (PPE), are selected and checked for serviceability
  • 1.5 Work is planned to minimise waste and use time efficiently
2. Undertake fabrication and installation activities
  • 2.1 Material is measured, marked out and cut according to job requirements and workplace instructions
  • 2.2 Specialist tools and equipment are used according to safety and environmental requirements
  • 2.3 Frame, canopies and side curtains are fabricated and assembled according to job requirements, workplace procedures, and safety and environmental requirements
  • 2.4 Frame, canopies and side curtains are installed and fastened according to workplace procedures and without causing damage to vehicle, vessel or components
  • 2.5 Installation and fastening are checked for correct operational requirements
3. Complete work processes
  • 3.1 Final inspection is made to ensure work meets workplace expectations and vehicle or vessel is presented ready for use
  • 3.2 Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored
  • 3.3 Tools and equipment are checked, reported if faulty, and stored according to workplace procedures
  • 3.4 Workplace documentation is processed according to workplace procedures
No information
No information
Replaces
State Code National Code Title Type
WF571 AURVTT3019 Fabricate and install canopies and curtains Unit of competency
Replaced By
State Code National Code Title Type
ODV83 AURVTT119 Fabricate and install automotive and marine frames, canopies and side curtains Unit of competency