Unit of competency Outline

Date retreived
22/07/2026 4:00 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Set computer controlled machines and processes

Set computer controlled machines and processes

Unit of competency
National Code
MEM07015
State Code
OAW39
TGA Status
Current
DTWD Status
Approved
Current Release Number
2.00
Current Release Date
31/03/2021
View on TGA
State Implementation and Classification
Approved Date
Field of Education
030707 - Metal Fitting, Turning And MacHining
Original Release Date
Nominal Hours
18
Description
This unit of competency defines the skills and knowledge required to set computer controlled machines and processes.All technical difficulties are resolved in consultation with appropriate technical advisers.Where the setting of non-computer controlled machines or processes is required unit MEM07003 Perform routine machine setting should be selected.Where the selection and use of general machining is required unit MEM07005 Perform general machining should be selected.No licensing, legislative or certification requirements apply to this unit at the time of publication.Band: AUnit Weight: 2
Notes
Elements and Performance Criteria
1 Determine job requirements
  • 1.1 Follow standard operating procedures (SOPs)
  • 1.2 Comply with work health and safety (WHS) requirements at all times
  • 1.3 Use appropriate personal protective equipment (PPE) in accordance with SOPs
  • 1.4 Identify job requirements from specifications, drawings, job sheets or work instructions
2 Mount work holding fixtures/devices/tools
  • 2.1 Prepare machine to accept work holding fixtures/devices/ tools
  • 2.2 Mount pre-set tooling into machine/equipment, as required
  • 2.3 Set work holding fixtures/devices on machine
  • 2.4 Identify/verify tool offset or datum settings against job sheet
  • 2.5 Load and select program and verify in accordance with job instructions
3 Conduct pre-start checks
  • 3.1 Undertake pre-start checks
  • 3.2 Observe correct safety procedures and check safety equipment for correct operation
4 Set machine
  • 4.1 Set/adjust machine to meet operational requirements and specifications
  • 4.2 Check production samples for compliance with specifications
  • 4.3 Replace pre-set tools, adjust tool offsets or take other corrective action in accordance with SOPs, as required
  • 4.4 Instruct operator, if necessary, ensuring that all safety procedures and devices are in place
No information
No information
Replaces
State Code National Code Title Type
W5360 MEM07015B Set computer controlled machines/processes Unit of competency