Unit of competency Outline

Date retreived
22/07/2026 6:05 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Perform laboratory testing

Perform laboratory testing

Unit of competency
National Code
NWPGEN009
State Code
AVZ27
TGA Status
Replaced
DTWD Status
Transition (Replaced)
Current Release Number
1.00
Current Release Date
07/12/2015
View on TGA
State Implementation and Classification
Approved Date
15/04/2016
Field of Education
019909 - Laboratory Technology
Original Release Date
15/04/2016
Nominal Hours
40
Description
This unit describes the skills required to perform laboratory tests using standard methods and procedures and with access to readily available advice.This unit applies to those working in the water industry, but could be used by other sectors. The skills and knowledge described in this unit must be applied within the legislative, regulatory and policy environment in which they are carried out. Organisational policies and procedures must be consulted and adhered to.Those undertaking this unit would work under indirect supervision, while performing complex tasks in a range of contexts.No licensing, legislative or certification requirements apply to unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare samples for testing
  • 1.1 Identify samples to be collected.
  • 1.2 Collect samples ensuring that types, locations and times comply with requirements.
  • 1.3 Maintain integrity of samples during sampling.
  • 1.4 Assess and report abnormal characteristics and apply incident management principles.
  • 1.5 Label, register and record laboratory samples, ensuring that the required information is transcribed accurately and legibly.
  • 1.6 Identify samples to be tested, appropriate test method, equipment and safety requirements.
2. Prepare for laboratory testing
  • 2.1 Set up test equipment and/or reagents in accordance with the specified test method.
  • 2.2 Conduct pre-use and safety checks.
  • 2.3 Identify and report faulty or unsafe equipment to appropriate personnel.
  • 2.4 Check the calibration status of equipment and conduct calibration or report calibration requirements to appropriate personnel.
3. Perform tests on samples
  • 3.1 Preserve the integrity of samples and eliminate the possibility of cross-contamination.
  • 3.2 Identify, prepare, and weigh or measure sample and standards to be tested.
  • 3.3 Follow test methods and perform sequence of tests using safety equipment.
  • 3.4 Perform calculations.
  • 3.5 Shut down equipment.
  • 3.6 Store unused reagents and dispose of wastes as required by relevant regulations and codes.
  • 3.7 Clean and store equipment.
4. Finalise work
  • 4.1 Apply chain of custody principles.
  • 4.2 Record results.
  • 4.3 Identify and report ‘out of specification’ or atypical results.
  • 4.4 Report observations or measurements requiring further action.
  • 4.5 Clear and restore work area.
No information
No information
Replaces
State Code National Code Title Type
D1939 NWP364B Perform laboratory testing Unit of competency
Replaced By
State Code National Code Title Type
OBO15 NWPGEN022 Perform laboratory testing Unit of competency