Carry out grouting or cementing operations

Unit of competency Outline

Date retreived
22/07/2026 11:36 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Unit of competency

National Code
RIINHB324D

State Code
WH491

TGA Status
Replaced

DTWD Status
Replaced

Current Release Number
2.00

Current Release Date
07/12/2014

View on TGA

State Implementation and Classification

Approved Date

28/05/2014

Field of Education

030303 - Mining Engineering

Original Release Date

28/05/2014

Nominal Hours

Description

This unit describes a participant’s skills and knowledge required to carry out grouting or cementing operations in Drilling. This unit is appropriate for those working in driller roles.No licensing, legislative or certification requirements apply to this unit at the time of publication

Notes

Elements and Performance Criteria

1. Plan and prepare for the grouting or cementing process

1.1 Access, interpret and apply grouting or cementing operations documentation and ensure the work activity is compliant
1.2 Obtain, read, interpret, clarify and confirm work requirements
1.3 Identify and address potential risks, hazards and environmental issues and implement control measures
1.4 Select and wear personal protective equipment appropriate for work activities
1.5 Communicate and coordinate activities with others throughout the work activity
1.6 Ensure adequate material and equipment is available to complete the task successfully
1.7 Obtain and interpret emergency procedures, and be prepared for fire/accident/emergency
1.8 Select the appropriate grouting or cementing procedure to suite the application

2. Perform measurement and calculations

2.1 Read tape measure accurately to carry out measurements of tank capacities, casing or rod lengths
2.2 Record or complete tally sheets for number of lengths of casing placed in the hole
2.3 Carry out calculations and measurements
2.4 Record legibly on all reports

3. Conduct grouting or cementing of hole

3.1 Start-up, run, and close down ancillary equipment
3.2 Manage mixing grout and any additives
3.3 Access, interpret and apply safety data sheets (SDS)
3.4 Conduct grouting or cementing of hole using appropriate equipment and techniques
3.5 Monitor process to ensure consistency and accuracy of placed grout or cement
3.6 Construct well head, hole identification and install hole security devices where required
3.7 Dispose of any excess grout or cement according to site waste management procedures

4. Respond to problems

4.1 Identify possible operational problems in equipment or process
4.2 Identify symptoms of problems needing remedial action
4.3 Determine possible fault causes
4.4 Rectify problem using appropriate solution within area of responsibility
4.5 Follow through items initiated until final resolution has occurred
4.6 Report problems outside area of responsibility to designated person

5. Complete equipment maintenance and housekeeping

5.1 Ensure there is no spillage of grout, cement or additives to minimise any associated safety hazards
5.2 Ensure cleaning equipment is used safely and effectively
5.3 Provide instructions and occupational health and safety requirements on the use of hazardous chemicals for cleaning
5.4 Maintain tools and equipment kept in good working condition
5.5 Ensure housekeeping activities are completed
5.6 Process records

No information

Replaces

State Code	National Code	Title	Type
WC364	RIINHB324B	Carry out grouting or cementing operations	Unit of competency

Replaced By

State Code	National Code	Title	Type
OBW16	RIINHB324E	Conduct grouting or cementing operations	Unit of competency

State Code	National Code	Title	Type
AZB1	RII31815	Certificate III in Drilling Operations	Qualification