Unit of competency Outline

Date retreived
22/07/2026 8:13 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Repair framing material finishes

Repair framing material finishes

Unit of competency
National Code
MSFPF2015
State Code
OAI48
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
03/12/2018
View on TGA
State Implementation and Classification
Approved Date
22/05/2019
Field of Education
030199 - Manufacturing Engineering And Technology, N.e.c.
Original Release Date
22/05/2019
Nominal Hours
44
Description
This unit describes the skills and knowledge required to prepare and use materials and equipment to repair damaged framing materials.This unit applies to picture framers and others completing work in accordance with a pre-determined work orders.No licensing or certification requirements exist at the time of publication. Relevant legislation, industry standards and codes of practice within Australia must be applied.
Notes
Elements and Performance Criteria
1 Prepare for work
  • 1.1 Read work order and identify repair requirements
  • 1.2 Inspect frame composition and finish of frame, determine the feasibility of effecting the repair and advise the relevant person
  • 1.3 Identify and follow work health and safety requirements throughout the work
  • 1.4 Plan the work sequence suited to the job
  • 1.5 Select and check tools and equipment for quality, serviceability and safety prior to use
2 Repair framing materials
  • 2.1 Measure, mix and use fillers and abrasive agents safely and effectively to remove or fill holes and other blemishes in materials
  • 2.2 Repair other defects in accordance with workplace procedures
  • 2.3 Match colours to suit existing finish of materials
  • 2.4 Apply finishes to materials in accordance with workplace procedures
  • 2.5 Problems occurring during repairs are identified and reported to appropriate persons
  • 2.6 Inspect repaired material to ensure best possible match to existing finish and store, return for further repair or scrap in accordance with workplace procedures
3 Complete work
  • 3.1 Mark completed work for identification and store in accordance with workplace procedures
  • 3.2 Identify and store items for recycling in accordance with workplace procedures
  • 3.3 Clean work area and safely dispose of rubbish
  • 3.4 Accurately complete required workplace documentation
  • 3.5 Check, clean and store tools and equipment in accordance with workplace procedures
No information
No information
Replaces
State Code National Code Title Type
WI587 MSFPF2008 Recognise and repair finishes of framing materials Unit of competency
State Code National Code Title Type
BED4 MSF30518 Certificate III in Picture Framing Qualification