Unit of competency Outline

Date retreived
23/07/2026 5:41 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Install adhesive fixed carpet

Install adhesive fixed carpet

Unit of competency
National Code
MSFFL3060
State Code
OAJ69
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
03/12/2018
View on TGA
State Implementation and Classification
Approved Date
22/05/2019
Field of Education
040321 - Floor Coverings
Original Release Date
22/05/2019
Nominal Hours
60
Description
This unit describes the skills and knowledge required to prepare, cut, lay, fix, join and finish, direct stick and dual-bonded carpet installations.This unit applies to flooring technicians installing carpet in accordance with pre-determined work orders.Licensing, legislative or certification requirements may apply to this unit and relevant state/territory and local government agencies should be consulted to determine any necessary certification or licensing for undertaking flooring work. Industry standards and codes of practice within Australia must also be applied. Access to construction sites requires certification of general induction training specified by the National Code of Practice for Induction for Construction Work (ASCC 2007).
Notes
Elements and Performance Criteria
1. Prepare for installation
  • 1.1 Identify and follow work health and safety, legislative and organisational requirements
  • 1.2 Consult floor inspection report to confirm suitability of floor for carpet installation
  • 1.3 Read documentation and identify work requirements and process
  • 1.4 Confirm sub-floor suitability for installation consistent with Australian Standards and manufacturer recommendations
  • 1.5 Select and check tools, equipment and materials for suitability, serviceability and safety prior to use
  • 1.6 Select and prepare suitable finishing, joining and fixing materials based on job requirements
  • 1.7 Plan sequence of work, including the starting point, to ensure efficiency and quality of installation
2. Set out materials
  • 2.1 Check carpet to be installed against order and acclimatise in accordance with manufacturer recommendations
  • 2.2 Check underlay and carpet to be installed against work instructions and appropriate standards
  • 2.3 Apply appropriate primers to the subfloor
3. Lay carpet flooring
  • 3.1 Identify and follow instructions and sequence for laying and fixing
  • 3.2 Check underlay is cut and installed to specification
  • 3.3 Lay out carpet pieces and check for size, direction of pile and pattern
  • 3.4 Trim carpet to shape, and cut and seal joins in accordance with manufacturer instructions and Australian Standards
  • 3.5 Apply adhesives in accordance with manufacturer instructions
  • 3.6 Lay carpet in accordance with manufacturer instructions and Australian Standards
  • 3.7 Fix cover and finishing strips suited to the type of sub-floor
  • 3.8 Install any required protective coverings as specified
  • 3.9 Inspect finished work for compliance with work order, workplace and Australian Standards
4. Complete housekeeping
  • 4.1 Store and recycle unused materials in accordance with workplace procedures
  • 4.2 Check, clean and store tools and equipment in accordance with workplace procedures
  • 4.3 Clean work area and dispose of rubbish safely
  • 4.4 Accurately complete required workplace documentation
No information
No information
Replaces
State Code National Code Title Type
WI363 MSFFL3006 Install adhesive fixed carpet floor coverings Unit of competency
Replaced By
State Code National Code Title Type
OEY62 MSFFL3110 Install adhesive-fixed carpet Unit of competency
State Code National Code Title Type
BED0 MSF30818 Certificate III in Flooring Technology Qualification