Unit of competency Outline

Date retreived
22/07/2026 2:38 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Cut timber or engineered wood product to profile

Cut timber or engineered wood product to profile

Unit of competency
National Code
FWPCOT3265
State Code
OAO16
TGA Status
Replaced
DTWD Status
Transition (Replaced)
Current Release Number
1.00
Current Release Date
18/12/2018
View on TGA
State Implementation and Classification
Approved Date
21/05/2019
Field of Education
030111 - Wood MacHining And Turning
Original Release Date
21/05/2019
Nominal Hours
20
Description
This unit of competency describes the skills and knowledge required to use profiling equipment for cutting timber or engineered wood products to a profile to produce moulded products in a manufacturing facility. The unit applies to individuals who work as benchman, machine operators, timber products technicians, production technicians and press operators. Operators generally work under broad or limited direction to complete routine activities related to their own work, and take responsibility for their work.All work must be carried out to comply with workplace procedures, according to state/territory health and safety regulations, legislation and standards that apply to the workplace. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for profiling timber or engineered wood products
  • 1.1 Review work order, specifications and workplace health and safety requirements, environmental protection practices and emergency procedures for timber profiling operations and, where required, check with appropriate personnel
  • 1.2 Identify and report hazards and use personal protective equipment according to workplace requirements and health and safety legislation to maintain safe work practices
  • 1.3 Obtain the type and quantity of material for profiling from a storage location
  • 1.4 Identify profile to be cut and select appropriate cutting blades according to specifications
2. Set up profiling equipment
  • 2.1 Use equipment according to workplace health and safety procedures, manufacturer instructions and environmental protection practices
  • 2.2 Follow lock-out procedures, select and attach machine guides and install cutting blades
  • 2.3 Set depth of cut or profile according to the required shape and to minimise waste
  • 2.4 Stack material in close proximity to maximise ease of machine feeding
  • 2.5 Test equipment set-up for correct profile alignment through a trial run and adjust as required
3. Cut timber or engineered wood product to profile
  • 3.1 Feed timber or engineered wood product into the machine at feed rate prescribed by organisational requirements
  • 3.2 Follow, maintain and adjust cutting sequence to produce the required quantity and maximise feed rate
  • 3.3 Check profiling process regularly and adjust to maintain desired depth and profile
  • 3.4 Dispose of incorrect cuts, off-cuts and defective material according to environmental protection practices
  • 3.5 Stack material safely in designated location according to work order
4. Complete operator maintenance
  • 4.1 Lock out equipment according to workplace health and safety procedures
  • 4.2 Check cutting blades for bluntness or damage according to manufacturer specifications
  • 4.3 Remove and replace cutting blades according to manufacturer recommendations
  • 4.4 Keep machine area clear of dust and debris according to workplace health and safety procedures
  • 4.5 Record and report production outcomes, equipment faults and maintenance requirements to appropriate personnel
No information
No information
Replaces
State Code National Code Title Type
AXL19 FWPCOT3244 Cut material to profile Unit of competency
Replaced By
State Code National Code Title Type
OBM30 FWPCOT3299 Cut timber or engineered wood product to profile Unit of competency
State Code National Code Title Type
BAM0 FWP30516 Certificate III in Timber Manufactured Products Qualification
BAM2 FWP30816 Certificate III in Woodmachining Qualification