Unit of competency Outline

Date retreived
22/07/2026 11:13 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Fabricate and install steel pressure piping

Fabricate and install steel pressure piping

Unit of competency
National Code
CPCPMS3031
State Code
OCN67
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
27/11/2020
View on TGA
State Implementation and Classification
Approved Date
01/06/2021
Field of Education
040327 - Plumbing
Original Release Date
01/06/2021
Nominal Hours
52
Description
This unit specifies the skills and knowledge required to determine installation requirements and to fabricate up to DN50, install and test steel pressure piping.It applies to pipe systems with operating pressures not exceeding 1750 kPa and 200⁰C.In some jurisdictions, this unit of competency may form part of accreditation, licensing, legislative, regulatory or certification requirements.
Notes
Elements and Performance Criteria
1 Identify installation requirements.
  • 1.1 Access, read and determine steel pressure pipe installation requirements from job specifications, relevant Australian Standards, codes, manufacturer’s specifications and jurisdictional requirements.
  • 1.2 Identify and apply workplace policies and procedures, work health and safety (WHS) and environmental requirements.
2 Prepare for work.
  • 2.1 Create a materials list and collect materials.
  • 2.2 Select and check serviceability of appropriate tools, equipment and personal protective equipment (PPE).
3 Fabricate, install and test pipe system.
  • 3.1 Set out pipework configuration.
  • 3.2 Perform installation of fixings and supports to manufacturer requirements, job plans, specifications and workplace requirements.
  • 3.3 Fabricate and joint pipe system according to job plans, specifications and manufacturer requirements for mechanical type joints.
  • 3.4 Perform installation of pipe system in specified location without damage or distortion to pipework or surrounding environment or other services.
  • 3.5 Perform testing of pipe system.
  • 3.6 Complete documentation according to relevant regulatory requirements and or workplace requirements.
4 Clean up.
  • 4.1 Clear the work area, and dispose of, reuse or recycle materials in accordance with state and territory legislation and workplace policies and procedures.
  • 4.2 Clean tools and equipment, check for serviceability and report any damage, and store and secure according to workplace procedures.
No information
No information
Replaces
State Code National Code Title Type
WF914 CPCPMS3031A Fabricate and install steel pressure piping Unit of competency
State Code National Code Title Type
BGC1 CPC32820 Certificate III in Fire Protection Qualification
BGB7 CPC32720 Certificate III in Gas Fitting Qualification
BGC2 CPC32420 Certificate III in Plumbing Qualification