Unit of competency Outline

Date retreived
22/07/2026 6:17 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Repair wall and floor tiling

Repair wall and floor tiling

Unit of competency
National Code
CPCCWF3004
State Code
OCP11
TGA Status
Current
DTWD Status
Approved
Current Release Number
2.00
Current Release Date
24/12/2024
View on TGA
State Implementation and Classification
Approved Date
01/06/2021
Field of Education
040313 - Ceiling, Wall And Floor Fixing
Original Release Date
01/06/2021
Nominal Hours
24
Description
This unit of competency specifies the skills and knowledge required to repair tiling by replacing wall and floor tiles. It includes preparing, removing and replacing wall and floor tiles and repairing and/or replacing waterproofing.A person working at this level would be expected to take responsibility for organising and completing tasks assigned to them without close supervision.Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of unit CPCWHS1001Prepare to work safely in the construction industry meets this requirement.Licensing, legislative or certification requirements apply to this unit in some states and territories and users are advised to check with the relevant regulatory authority.
Notes
Elements and Performance Criteria
1 Plan and prepare to repair wall and floor tiling.
  • 1.1 Read and interpret task work instructions and plan sequence of work.
  • 1.2 Select and use personal protective equipment (PPE) as required for each task stage.
  • 1.3 Plan all work to comply with laws and regulations, Australian Standards, work health and safety (WHS) and environmental requirements, manufacturers’ specifications, workplace requirements, drawings and specifications.
  • 1.4 Inspect work site, assess hazards and apply risk controls, including required signage and barricades.
  • 1.5 Select tools and equipment, check for serviceability and report any faults.
  • 1.6 Select materials required for task, calculate quantities, handle safely and prepare and position ready for use.
2 Repair damaged tiles
  • 2.1 Remove damaged or defective tiles avoiding damage to surrounding tiles.
  • 2.2 Clean and clear old bedding to allow installation of replacement tile.
  • 2.3 Repair or replace existing waterproofing.
  • 2.4 Select and cut replacement tiles to match surrounding tiles.
  • 2.5 Install tiles to maintain alignment with joints.
  • 2.6 Carry out grouting and clean tiles.
3 Clean up.
  • 3.1 Clear work area and dispose of, reuse or recycle materials.
  • 3.2 Clean, check, maintain and store plant, tools and equipment in accordance with manufacturers’ recommendations.
No information
No information
Replaces
State Code National Code Title Type
W9613 CPCCWF3004A Repair wall and floor tiles Unit of competency
State Code National Code Title Type
BGC8 CPC20220 Certificate II in Construction Pathways Qualification
BGE1 CPC31320 Certificate III in Wall and Floor Tiling Qualification