Unit of competency Outline

Date retreived
23/07/2026 11:57 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Set up and tune a process

Set up and tune a process

Unit of competency
National Code
MSMPMC401
State Code
OAF32
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
22/10/2018
View on TGA
State Implementation and Classification
Approved Date
21/05/2019
Field of Education
030717 - Plant And Machine Operations
Original Release Date
21/05/2019
Nominal Hours
40
Description
This unit describes the skills and knowledge required to set up and tune a process as typically required for start-up, job change and equipment changes in preparation for production.This unit applies to experienced operators, leading hands, supervisors or those in similar roles who are required to shut down and isolate equipment, prepare and set up equipment, adjust to remedy faults and non-conformity and solve problems within area of responsibility. This unit applies to an experienced operator demonstrating broad theoretical and technical knowledge and well-developed skills in situations that require some discretion and judgement. The experienced operator may work alone or as part of a team or group and in liaison with other shift team members, team leader and supervisor. No licensing or certification requirements exist at the time of publication. Relevant legislation, industry standards and codes of practice within Australia must be applied.
Notes
Elements and Performance Criteria
1. Prepare for equipment installation or change parts
  • 1.1 Identify all safety and emergency procedures
  • 1.2 Shut down equipment in accordance with procedures and manufacturer specifications
  • 1.3 Isolate equipment
  • 1.4 Remove ancillary equipment
  • 1.5 Complete records and logs for removal of equipment or change parts
2. Prepare the proess for production
  • 2.1 Consult the production schedule to determine the product to be manufactured
  • 2.2 Ensure that the raw materials are available
  • 2.3 Ensure that the equipment or change parts, ancillaries and fixtures are available
  • 2.4 Perform pre-instalment equipment preparation according to procedures
  • 2.5 Check that the equipment is in a safe condition for use
3. Set up process
  • 3.1 Perform checks and tests to product and equipment specifications
  • 3.2 Check alignment of all equipment according to product specifications and procedures
  • 3.3 Check that process or equipment is set up as required for the production schedule
4. Tune the process
  • 4.1 Monitor operation and compare with standard operating procedures (SOPs)
  • 4.2 Identify any deviation from standard performance
  • 4.3 Identify the cause of the deviation and act
  • 4.4 Adjust the equipment settings, process conditions or raw materials to bring production into specification
  • 4.5 Continue monitoring operation and adjusting until product or equipment is within specification
5. Respond to problems
  • 5.1 Identify routine and non-routine problems in the equipment or process
  • 5.2 Rectify problem using appropriate solution within area of responsibility
  • 5.3 Report problems outside area of responsibility to designated person
6. Control hazards
  • 6.1 Identify hazards associated with the equipment or process
  • 6.2 Assess the risks arising from those hazards
  • 6.3 Implement measures to control those risks
No information
No information
Replaces
State Code National Code Title Type
BAH27 PMC553000 Set up and tune a process Unit of competency