Unit of competency Outline

Date retreived
23/07/2026 10:14 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Install and test vision systems

Install and test vision systems

Unit of competency
National Code
CUAVSS301
State Code
WI231
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
2.00
Current Release Date
15/01/2016
View on TGA
State Implementation and Classification
Approved Date
16/05/2014
Field of Education
100701 - Audio Visual Studies
Original Release Date
16/05/2014
Nominal Hours
55
Description
This unit describes the performance outcomes, skills and knowledge required to install vision equipment and conduct pre-production or event checks according to vision system plans.At this level, individuals are required to use some discretion and judgement and operate under broad supervision within an established framework of plans and procedures.The National Standard for Licensing Persons Performing High Risk Work applies to persons performing dogging and rigging work. Completion of the following units is required for certification at either basic, intermediate or advanced levels:CPCCLDG3001A Licence to perform doggingCPCCLRG3001A Licence to perform rigging basic levelCPCCLRG3002A Licence to perform rigging intermediate levelCPCCLRG4001A Licence to perform rigging advanced levelSets and staging for some performances or events may fall within the definition of construction work. If so, people entering a construction site are required to complete the general induction training program specified by the National Code of Practice for Induction Training for Construction Work (Australian Safety Compensation Council, May 2007).Achievement of the unit ‘CPCCOHS1001A Work safely in the construction industry’ fulfils this requirement.
Notes
Elements and Performance Criteria
1. Prepare for vision system installation
  • 1.1 Confirm vision system requirements in consultation with relevant personnel and with reference to vision system plans
  • 1.2 Calculate rigging, cabling and power requirements according to vision system plans
  • 1.3 Assemble and test equipment, accessories and consumables to ensure they are working and prepared for installation
  • 1.4 Recognise faults and take appropriate remedial action
  • 1.5 Pre-rig vision system equipment as specified in vision system plans and according to licensing regulations
  • 1.6 Prepare extension leads, looms and cables according to design specifications and regulatory requirements
  • 1.7 Construct or devise effects and masking as required
  • 1.8 Establish contingency plans in the event of equipment malfunction and prepare backup equipment
2. Complete installation tasks
  • 2.1 Determine the positioning of, and support requirements for, vision system equipment
  • 2.2 Install supports or check that rigging and mounts have been installed in the appropriate position
  • 2.3 Use safe lifting and handling techniques to install primary and backup vision systems
  • 2.4 Lay and secure power and other cables to avoid damage and hazardous situations
  • 2.5 Complete work tasks within production or event deadlines
3. Test equipment
  • 3.1 Patch and test equipment and accessories to ensure operational efficiency and working order
  • 3.2 Check operation of equipment in conjunction with other technical areas as required
  • 3.3 Identify problems and modify installation or technical elements of equipment in consultation with relevant personnel
  • 3.4 Complete and distribute workplace documentation as required
No information
No information
Replaces
State Code National Code Title Type
D1621 CUEAUD02C Prepare, rig, test and modify vision systems Unit of competency
Replaced By
State Code National Code Title Type
ODF91 CUAVSS311 Install and test vision systems Unit of competency