Unit of competency Outline

Date retreived
22/07/2026 4:13 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Conduct non-destructive testing

Conduct non-destructive testing

Unit of competency
National Code
AURM340550B
State Code
D7602
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
21/06/2011
View on TGA
State Implementation and Classification
Approved Date
11/04/2013
Field of Education
030503 - Vehicle Mechanics
Original Release Date
11/04/2013
Nominal Hours
30
Description
This unit of competency describes the skills and knowledge required to perform non-destructive testing on competition vehicle components and materials.It requires the ability to use technical skills to prepare for and conduct non-destructive testing. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for non-destructive testing
  • 1.1. Use team instructions, controlling body rules, category rules, supplementary regulations and component supplier specifications to determine job requirements, including quality, materials, equipment and quantities
  • 1.2. Observe occupational health and safety (OHS) requirements, including regulatory requirements and personal protection needs, throughout the work
  • 1.3. Clean and prepare inspection areas for testing using procedures and materials
  • 1.4. Check tooling and equipment for safe and effective operation
  • 1.5. Prepare test equipment for non-destructive testing in accordance with equipment manufacturer/supplier instructions and team requirements
  • 1.6. Report problems with the work area or the operation of equipment to appropriate persons
2. Perform non-destructive testing
  • 2.1. Specify testing methods using standard operating procedures and team requirements
  • 2.2. Identify hazards associated with testing and identify safety requirements
  • 2.3. Carry out testing in accordance with task instructions, team procedures and OHS requirements
  • 2.4. Identify non-conformance and defects against component manufacturer/supplier specifications and team standards
  • 2.5. Verify test results
  • 2.6. Document test results in accordance with team procedures
3. Clean up work area
  • 3.1. Maintain and store testing equipment in accordance with team procedures and OHS requirements
  • 3.2. Clean and prepare work area for subsequent use
No information
No information
Replaces
State Code National Code Title Type
W2891 AURM340550A Conduct non-destructive testing Unit of competency
Replaced By
State Code National Code Title Type
WF280 AURMTA3007 Conduct non-destructive testing Unit of competency
State Code National Code Title Type
D791 AUR31311 Certificate III in Automotive Engine Reconditioning Qualification
D543 AUR30911 Certificate III in Motorsport Qualification