Unit of competency Outline

Date retreived
22/07/2026 2:34 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Construct a basic timber furnishing product

Construct a basic timber furnishing product

Unit of competency
National Code
MSFFM1001
State Code
WI408
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
030113 - Cabinet Making
Original Release Date
19/06/2014
Nominal Hours
80
Description
This unit of competency covers constructing, assembling and finishing a basic timber furnishing product. It applies to a VET in Schools or pre-vocational program for new entrants to the furnishing industry.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Prepare for work
  • 1.1 Work instructions are used to determine job requirements, including design variations, tolerances, process, materials, finish and quantity
  • 1.2 Construction and assembly sequence are planned
  • 1.3 Procedures are determined for checking quality at each stage of the process
  • 1.4 Work health and safety (WHS) requirements, including personal protection needs, are observed throughout the work
  • 1.5 Suitable work area is selected for the task
  • 1.6 Preparatory drawings/set-outs for tasks are confirmed
  • 1.7 Cutting list for project components is accessed and interpreted
  • 1.8 Materials are selected following work instructions
  • 1.9 Tools and equipment suitable for construction are identified and checked for safe and effective operation
2 Complete construction
  • 2.1 Material is set out and prepared according to work instructions and components are marked according to workplace procedures
  • 2.2 Tools, machines and equipment are used in accordance with safety requirements and manufacturer specifications
  • 2.3 Components are manufactured, including any specified shapes, angles or curves, and checked against set-outs and job requirements
  • 2.4 Components are assembled using jigs and/or clamps and fastenings
  • 2.5 Adhesives are applied according to workplace procedures and/or manufacturer instructions
  • 2.6 Joining process is undertaken according to workplace procedures
  • 2.7 Assembled product is checked for compliance with specifications
  • 2.8 Item is finished in accordance with work instructions
3 Finalise operation and maintain equipment
  • 3.1 Work area is cleaned, hand and/or power tools and equipment are cleaned, maintained and stored in accordance with workplace procedures
  • 3.2 Off-cuts and unused materials are collected and stored for re-use or disposed of following workplace procedures
  • 3.3 Waste and scrap materials are dealt with following workplace procedures
No information
No information
Replaces
State Code National Code Title Type
W8597 LMFFM1001B Construct a basic timber furnishing product Unit of competency
Replaced By
State Code National Code Title Type
OEJ55 MSFFP2011 Use timber furnishing construction techniques Unit of competency
State Code National Code Title Type
J724 MSF10113 Certificate I in Furnishing Qualification