Unit of competency Outline

Date retreived
22/07/2026 2:08 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Apply sheet laminates by hand

Apply sheet laminates by hand

Unit of competency
National Code
MSFFM2004
State Code
WI413
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
030113 - Cabinet Making
Original Release Date
19/06/2014
Nominal Hours
8
Description
This unit of competency covers preparing, laying out, applying and finalising processes for applying sheet laminates by hand.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Prepare the work
  • 1.1 Work instructions are used to determine job requirements, including process, materials, finish and quantity
  • 1.2 Application sequence is planned
  • 1.3 Procedures are determined for checking quality at each stage of the process
  • 1.4 Work health and safety (WHS) requirements, including personal protection needs, are observed throughout the work
  • 1.5 Suitable work area is selected for the task
  • 1.6 Tools and equipment suitable for application are identified and checked for safe and effective operation
2 Lay out and prepare materials
  • 2.1 Substrata (surfaces to be laminated) are prepared for laminating
  • 2.2 Laminates are selected and checked for flaws following work instructions
  • 2.3 Laminates are prepared for application and laid out
  • 2.4 Suitable joining processes are selected and prepared
3 Apply fit and finish
  • 3.1 Tools and equipment are used in accordance with workplace procedures, including use of personal protective equipment
  • 3.2 Laminates are measured, marked and cut to size
  • 3.3 Adhesives are applied according to workplace procedures and/or manufacturer instructions and the laminate applied to the substrata (base material)
  • 3.4 Laminates are rolled or hammered to secure according to enterprise practices
  • 3.5 Final trim and finishing are completed to specifications
  • 3.6 Work is checked against required quality standards
4 Finalise operation and maintain equipment
  • 4.1 Work area is cleaned, hand and/or power tools and equipment are cleaned, maintained and stored in accordance with workplace procedures
  • 4.2 Tools and equipment are cleaned and left in a safe mode
  • 4.3 Faulty and/or defective equipment is tagged and reported in accordance with workplace practices
  • 4.4 Off-cuts and unused materials are collected and stored for re-use or disposal following workplace procedures
  • 4.5 Waste and scrap materials are dealt with following workplace procedures
No information
No information
Replaces
State Code National Code Title Type
W8601 LMFFM2004B Apply sheet laminates by hand Unit of competency
Replaced By
State Code National Code Title Type
OEL23 MSFFM2015 Apply sheet laminates by hand Unit of competency