Unit of competency Outline

Date retreived
22/07/2026 9:58 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Join band saw blades

Join band saw blades

Unit of competency
National Code
FWPSAW3245
State Code
OBM08
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
31/01/2020
View on TGA
State Implementation and Classification
Approved Date
29/05/2020
Field of Education
030715 - Precision Metalworking
Original Release Date
29/05/2020
Nominal Hours
40
Description
This unit of competency describes the skills and knowledge required to assess the condition of band saw blades, prepare and weld meeting ends and finish the welded surface ready for operation.The unit applies to individuals who join band saw blades in a saw technician workshop or sawmill.All work must be carried out to comply with workplace procedures, according to state/territory health and safety regulations, legislation and standards that apply to the workplace.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for joining
  • 1.1 Review work order to determine job requirements and, where required, seek clarification from appropriate personnel
  • 1.2 Review workplace health and safety procedures, including the use of personal protective equipment, equipment lock-out and safe manual handling techniques
  • 1.3 Identify, assess and take actions to mitigate risks and hazards associated with joining band saw blades
  • 1.4 Identify workplace environmental protection procedures for minimising and disposing of waste material, cleaning tools and equipment, and maximising energy efficiency
  • 1.5 Select appropriate repair and maintenance equipment and check for operational effectiveness according to manufacturer recommendations
2. Join or repair band saw blade
  • 2.1 Obtain saw blank and cut to length or cut existing blade at weld defect
  • 2.2 Trim ends to obtain correct back alignment and pitch and/or shape to assist metal penetration
  • 2.3 Set up and pre-heat blade ends and jig to specified tolerances
  • 2.4 Apply weld to ensure metal penetrates through blade thickness and is protected from accidental contact
  • 2.5 Loosen clamps and anneal joint immediately after welding
  • 2.6 Grind surplus weld material from blade without overheating
3. Finish band saw blade
  • 3.1 Finish blade to eliminate bumps in blade surface
  • 3.2 Identify damaged blades or those with sub-standard joins, and dispose of these according to environmental protection practices
  • 3.3 Package band saw for protection during return to service
  • 3.4 Identify routine processing and equipment faults and resolve or report to appropriate personnel
No information
No information
Replaces
State Code National Code Title Type
AXJ93 FWPSAW3214 Join band saw blades Unit of competency