Unit of competency Outline

Date retreived
22/07/2026 8:24 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Install furnishing products

Install furnishing products

Unit of competency
National Code
MSFFM3006
State Code
WI427
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
19/06/2014
Field of Education
030113 - Cabinet Making
Original Release Date
19/06/2014
Nominal Hours
20
Description
This unit of competency covers the installation of furnishing products to a given plan.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Prepare for work
  • 1.1 Work instructions are used to determine job requirements, including location, type of installation, tolerances, process, finish and quality
  • 1.2 Installation location and sequence are planned
  • 1.3 Procedures are determined for checking quality at each stage of the process
  • 1.4 Work health and safety (WHS) requirements, including personal protection needs, are observed throughout the work
  • 1.5 Hardware, fittings and attachments are collected
  • 1.6 Tools and equipment suitable for installation are identified and checked for safe and effective operation
  • 1.7 Fixing and joining devices are selected in line with work instructions and types of materials
  • 1.8 Required installation aids are selected and checked for suitability for purpose
2 Complete installation
  • 2.1 Site is prepared for installation
  • 2.2 Furnishing products are prepared to site requirements
  • 2.3 Hand and/or power tools and equipment are used in accordance with workplace requirements, including use of personal protective equipment
  • 2.4 Fixing methods are undertaken according to site conditions
  • 2.5 Installed furniture product is checked for compliance with specification
  • 2.6 Tops and/or appliances are installed in accordance with plans and specifications
  • 2.7 Hardware and decorative accessories are installed
  • 2.8 Work is checked against required quality standards
3 Finalise operation and maintain equipment
  • 3.1 Work area is cleaned, hand and/or power tools and equipment are cleaned, maintained and stored in accordance with workplace procedures
  • 3.2 Machinery is cleaned and left in a safe mode
  • 3.3 Faulty and/or defective equipment is tagged and reported in accordance with workplace practices
  • 3.4 Unused hardware is collected and stored for re-use or disposal following workplace procedures
  • 3.5 Waste and scrap materials are dealt with following workplace procedures
No information
No information
Replaces
State Code National Code Title Type
W8615 LMFFM3006B Install furnishing Unit of competency
Replaced By
State Code National Code Title Type
OEJ94 MSFFM3043 Install cabinetry Unit of competency