Qualification Outline
21/07/2026 11:10 PM AWST
Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.
Diploma of Aeroskills (Mechanical)
Diploma of Aeroskills (Mechanical)
MEA50211
D751
Replaced
Replaced
National Endorsed, State Implementation and Classification
Releases
| Release Version | Release Date | TGA Status | DTWD Status |
|---|---|---|---|
| 2.00 | 23/08/2013 | Current | Approved |
Description
This qualification applies to individuals seeking the grant of a CASA B1 Aircraft Maintenance Engineer Licence covering the supervision, performance and certification of airframe, engine, electrical and structural maintenance on aircraft that are type-rated by CASA for maintenance purposes.
The requirement for the awarding of MEA50211 Diploma of Aeroskills (Mechanical) is demonstrated competency in listed competency units under the conditions set out below. The listed units also satisfy CASA requirements for the grant, under CASR Part 66, of Aircraft Maintenance Engineer B1 Licences in sub-categories B1.1, 1.2, 1.3 and 1.4 when the skills and knowledge requirements align with CASA syllabus requirements in under ‘Licensing’ in the Assessment Guidelines and in Appendix 1, and training has been delivered in accordance with the requirements of CASR Part 147.
It consists of:
common and technical stream units required at Certificate IV level in the aircraft maintenance stream with electives determined by the desired licence sub-category
additional Diploma level common units that cover supervisor level OHS competency plus competencies required by CASA for the exercise of licence privileges
Diploma level mechanical technical stream units covering advanced fault diagnosis and aircraft weighing and weight and balance calculation.
Schedule
Packaging Rules
To be awarded the MEA50211 Diploma of Aeroskills (Mechanical), competency must be demonstrated in thirty six (36) to forty two (42) units, chosen as described below.All B1 licence sub-categories require the following twenty eight (28) or twenty nine (29) units:
- ten (10) Core Diploma level (CASA licensing) common, technical stream and imported units
- seventeen (17) Core Certificate IV common and technical stream units
- elective technical stream units in either Group A (one unit) or Group B (two units).
Depending on the CASA B1 licence sub-category being sought, an additional eight (8) to thirteen (13) units are required, up to a maximum of forty two (42) units for the qualification. All units must be chosen as specified under the conditions set out below:
- Group C Elective technical stream units required by CASA for a B1.1 licence - 11 or 13 units
- Group D Elective technical stream units required by CASA for a B1.2 licence - 12 units
- Group E Elective technical stream units required by CASA for a B1.3 licence - 9 units
- Group F Elective technical stream units required by CASA for a B1.4 licence - 8 units
1. Diploma CACA Licensing Core Units
All ten (10) units must be completed
2. Certificate IV Core Units - CASA B1 Licence
All seventeen (17) units must be completed
3. Group A Technical Unit
One (1) unit may be chosen from Group A.
Please refer to the packaging rules for the full details of available options.
| State Code | National Code | Title | Hours | Type |
|---|---|---|---|---|
| D4400 | MEA211C | Inspect, test and troubleshoot advanced aircraft electrical systems and components | 140 | Unit of competency |
4. Group B Technical Elective Units
Two (2) units may be completed from Group B.
Please refer to the packaging rules for the full details of available options.
5. Group C B1.1 Licence Units
Complete eleven (11) or (13) units from Group C if a B1.1 licence is chosen.
Please refer to the packaging rules for the full details of available options.
6. Group D B1.2 Licence Units
Twelve (12) units to be completed from Group D if a B1.2 licence is chosen.
Please refer to the packaging rules for the full details of available options.
7. Group E B1.3 Licence Units
Nine (9) units to be completed from Group E if a B1.3 Licence is chosen.
(Noting that MEA308C and MEA316C each count as two (2) units).
Please refer to the packaging rules for the full details of available options.
| State Code | National Code | Title | Hours | Type |
|---|---|---|---|---|
| WC015 | MEA319C | Inspect gas turbine engine systems and components | 80 | Unit of competency |
| D4424 | MEA309C | Inspect, test and troubleshoot aircraft hydro-mechanical and landing gear systems and components | 120 | Unit of competency |
| D4426 | MEA310C | Inspect, test and troubleshoot aircraft pneumatic systems and components | 60 | Unit of competency |
| D4432 | MEA316C | Inspect, test and troubleshoot rotary wing rotor and control systems and components | 80 | Unit of competency |
| D4419 | MEA304C | Remove and install non-pressurised aircraft structural and non-structural components | 60 | Unit of competency |
| D4423 | MEA308C | Remove and install rotary wing rotor and flight control system components | 60 | Unit of competency |
| WC027 | MEA322C | Test and troubleshoot gas turbine engine systems and components | 60 | Unit of competency |
8. Group F B1.4 Licence Units
Eight (8) units to be completed from Group F if a B1.4 licence is required.
(Noting that MEA308C and MEA316C each count as two (2) units).
Please refer to the packaging rules for the full details of available options.
| State Code | National Code | Title | Hours | Type |
|---|---|---|---|---|
| D4424 | MEA309C | Inspect, test and troubleshoot aircraft hydro-mechanical and landing gear systems and components | 120 | Unit of competency |
| D4426 | MEA310C | Inspect, test and troubleshoot aircraft pneumatic systems and components | 60 | Unit of competency |
| D4429 | MEA313C | Inspect, test and troubleshoot piston engine systems and components | 120 | Unit of competency |
| D4432 | MEA316C | Inspect, test and troubleshoot rotary wing rotor and control systems and components | 80 | Unit of competency |
| D4419 | MEA304C | Remove and install non-pressurised aircraft structural and non-structural components | 60 | Unit of competency |
| D4423 | MEA308C | Remove and install rotary wing rotor and flight control system components | 60 | Unit of competency |
Replaces
| State Code | National Code | Title | Type |
|---|---|---|---|
| S754 | MEA50210 | Diploma of Aeroskills (Mechanical) | Qualification |
Replaced By
| State Code | National Code | Title | Type |
|---|---|---|---|
| AVO6 | MEA50215 | Diploma of Aeroskills (Mechanical) | Qualification |
No information
Entry Requirements
Not applicable.
Traineeships and Apprenticeships