Unit of competency Outline

Date retreived
22/07/2026 7:57 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Cut material using high speed optimiser

Cut material using high speed optimiser

Unit of competency
National Code
FWPCOT3206
State Code
AXL56
TGA Status
Replaced
DTWD Status
Transition (Replaced)
Current Release Number
1.00
Current Release Date
13/05/2016
View on TGA
State Implementation and Classification
Approved Date
05/10/2016
Field of Education
030111 - Wood MacHining And Turning
Original Release Date
05/10/2016
Nominal Hours
35
Description
This unit of competency describes the outcomes required to prepare and cut material to differing lengths and angles using computer programmable optimising saws. It requires the ability to select and load computer programs and cutting sequences, assess problems and determine appropriate responses. Work is completed in a forest products factory setting.The unit applies to Machine Operator, Sawmill Worker, Engineered Timber Products Technician, Production Technician. No licensing, legislative, regulatory, or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for cutting
  • 1.1 Review work order and where required check with appropriate personnel.
  • 1.2 Select appropriate personal protective equipment and check for operational effectiveness.
  • 1.3 Obtain type and quantity of material to be cut from storage location.
  • 1.4 Identify required cutting patterns and saw setup sequences.
  • 1.5 Check cutting equipment, make adjustments and start in line with manufacturer recommendations.
2. Operate programmed machinery
  • 2.1 Select and set computer program to job specifications and check machine cycle.
  • 2.2 Complete trial run to check system operation and check board for length and angle specification within set tolerance.
  • 2.3 Use equipment in line with organisational safety procedures, manufacturer’s instructions and environmental protection practices.
  • 2.4 Load materials into machine, operate saw and monitor use regularly to minimise waste and ensure correct lengths and angles are produced.
  • 2.5 Monitor processing regularly to ensure continuity of material flow, and quality and quantity of production output.
  • 2.6 Dispose of incorrect cuts, off-cuts and material with defects in line with environmental protection practices.
  • 2.7 Identify routine processing problems and resolve or report to appropriate personnel.
3. Monitor and adjust processing
  • 3.1 Follow organisational safety procedures to lock out equipment.
  • 3.2 Check saw blades for bluntness or damage.
  • 3.3 Remove and replace saw blades in line with manufacturer's recommendations.
  • 3.4 Dispose of used blades in line with environmental protection practices.
  • 3.5 Keep work area clear of dust and debris in line with organisational safety procedures.
  • 3.6 Record and report production outcomes, equipment faults and maintenance requirements to appropriate personnel.
No information
No information
Replaces
State Code National Code Title Type
D5917 FPICOT3206B Cut material using high speed optimiser Unit of competency
Replaced By
State Code National Code Title Type
OBM55 FWPCOT3274 Cut timber products using high-speed optimiser Unit of competency