Unit of competency Outline

Date retreived
22/07/2026 3:22 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Cut timber products using high-speed optimiser

Cut timber products using high-speed optimiser

Unit of competency
National Code
FWPCOT3274
State Code
OBM55
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
31/01/2020
View on TGA
State Implementation and Classification
Approved Date
29/05/2020
Field of Education
030111 - Wood MacHining And Turning
Original Release Date
29/05/2020
Nominal Hours
35
Description
This unit of competency describes the skills and knowledge required to prepare and cut timber products to differing lengths and angles using computer numerical control (CNC) optimising docking and trimming saws. The unit applies to individuals who cut timber products using a high-speed optimiser in a timber processing or timber product manufacturing plant.All work must be carried out to comply with workplace procedures, according to state/territory health and safety regulations, legislation and standards that apply to the workplace.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for cutting timber product
  • 1.1 Review work order to determine job requirements and, where required, seek clarification from appropriate personnel
  • 1.2 Review workplace health and safety procedures, including the use of personal protective equipment, equipment lock-out and safe manual handling techniques
  • 1.3 Identify, assess and take actions to mitigate risks and hazards associated with cutting timber products using a high-speed optimiser
  • 1.4 Identify workplace environmental protection procedures for minimising and disposing of waste material, cleaning tools and equipment, and maximising energy efficiency
  • 1.5 Obtain type and quantity of timber product to be cut from a storage location
  • 1.6 Identify required cutting patterns and saw set-up sequences
2. Operate CNC optimising saws
  • 2.1 Perform pre-operational checks according to manufacturer and workplace procedures
  • 2.2 Select and set computer software program to job specifications and check machine cycle
  • 2.3 Complete trial run to verify system operation and check timber product for length and angle specification within the set tolerance
  • 2.4 Use machine according to workplace safety procedures, manufacturer instructions and environmental protection practices
  • 2.5 Load timber product into the machine and operate to minimise waste and ensure correct lengths and angles are produced
  • 2.6 Monitor the process regularly to ensure continuity of material flow, and quality and quantity of production output
  • 2.7 Redirect incorrect cuts, off-cuts and timber product with defects for reuse, recycling or disposal according to workplace procedures and environmental protection practices
  • 2.8 Identify routine processing problems, and resolve or report to appropriate personnel
3. Perform operator maintenance
  • 3.1 Lock out machine and equipment according to workplace safety procedures
  • 3.2 Check saw blades for bluntness or damage
  • 3.3 Remove and replace saw blades according to manufacturer recommendations
  • 3.4 Dispose of used blades according to environmental protection practices
  • 3.5 Keep the work area clear of dust and debris according to workplace safety procedures
  • 3.6 Record and report production outcomes, equipment faults and maintenance requirements to appropriate personnel
No information
No information
Replaces
State Code National Code Title Type
AXL56 FWPCOT3206 Cut material using high speed optimiser Unit of competency