Unit of competency Outline

Date retreived
22/07/2026 10:23 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Remove and replace adhesive attached components on vehicles

Remove and replace adhesive attached components on vehicles

Unit of competency
National Code
AURVTN005
State Code
AWZ88
TGA Status
Current
DTWD Status
Approved
Current Release Number
1.00
Current Release Date
14/04/2016
View on TGA
State Implementation and Classification
Approved Date
13/07/2016
Field of Education
030509 - Automotive Body Construction
Original Release Date
13/07/2016
Nominal Hours
20
Description
This unit describes the performance outcomes required to remove and replace adhesive attached components on vehicles. It involves preparing for the task, selecting and using tools and equipment, removing and replacing mouldings, badges, transfers and decals, selecting adhesives according to manufacturer specifications, and completing workplace processes and documentation.It applies to those working in the automotive body service and repair industry.No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare to remove and replace adhesive attached components on vehicles
  • 1.1 Job requirements are determined from workplace instructions
  • 1.2 Removal and replacement information for adhesive attached components is sourced and interpreted from manufacturer specifications and workplace procedures
  • 1.3 Mouldings and decals are sourced and inspected for quality
  • 1.4 Hazards associated with the work are identified and risks are managed
  • 1.5 Tools and equipment, including personal protective equipment (PPE), are identified and checked for serviceability
  • 1.6 Work is planned and removal and replacement procedures are identified to prevent damage to vehicle
2. Remove adhesive attached components on vehicles
  • 2.1 Removal of adhesive attached components is completed using approved equipment from manufacturer, including hot air guns
  • 2.2 Reusable adhesive attached components are inspected and cleaned in preparation for replacement
  • 2.3 Work is completed according to safety and environmental requirements and without causing damage to system and components, including adhesive attached components
3. Attach adhesive components on vehicles
  • 3.1 Components to be replaced are checked and confirmed to be within manufacturer specifications
  • 3.2 Adhesive is selected and applied according to product specification
  • 3.3 Attached components are checked for fit and alignment, and to ensure that they are free of air bubbles
4. Complete work processes
  • 4.1 Final inspection is made to ensure work meets workplace expectations and vehicle is presented ready for use
  • 4.2 Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored
  • 4.3 Tools and equipment are checked, reported if faulty, and stored according to workplace procedures
  • 4.4 Workplace documentation is processed according to workplace procedures
No information
No information
Replaces
State Code National Code Title Type
WF488 AURVTN2005 Remove and fit protector mouldings, transfers and decals Unit of competency