Unit of competency Outline

Date retreived
22/07/2026 6:21 AM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Assemble leadlight and stained glass components

Assemble leadlight and stained glass components

Unit of competency
National Code
MSFSL2001
State Code
WI643
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
10/12/2013
View on TGA
State Implementation and Classification
Approved Date
20/06/2014
Field of Education
040323 - Glazing
Original Release Date
20/06/2014
Nominal Hours
50
Description
This unit of competency covers assembling leadlight and stained glass components using a range of fixing and joining components.No licensing, legislative or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1 Plan and prepare for work
  • 1.1 Applicable work health and safety (WHS), legislative and organisational requirements relevant to the assembly of leadlight and stained glass components are verified and complied with
  • 1.2 Tools and equipment selected to carry out tasks are consistent with the requirements of the job, checked for serviceability, and any faults rectified or reported prior to commencement
  • 1.3 Materials appropriate to the work application are identified, obtained, prepared, safely handled and located ready for use
  • 1.4 Workplace environment considerations are identified and measures to reduce noise, dust and obstacles are applied
  • 1.5 Assembly sequence is planned
  • 1.6 Fixing and joining devices are selected in accordance with work instructions and type of materials to be joined
  • 1.7 Jigs are selected and checked for suitability of purpose
2 Assemble components
  • 2.1 Components are laid out and assembled using jigs and appropriate fastenings
  • 2.2 Hand and/or power tools, and equipment are used, as required
  • 2.3 Assembled work is checked for compliance with specifications
  • 2.4 Components are prepared, assembled and fitted in accordance with specifications
  • 2.5 Work which does not meet quality specifications is repaired or tagged for further processing or recycling/disposal
  • 2.6 Finished products are organised and stored in holding area
3 Clean work area and maintain equipment
  • 3.1 Faulty and/or defective equipment is tagged and reported in accordance with workplace procedures
  • 3.2 Waste and scrap are removed following workplace procedures
  • 3.3 Tools and equipment used are cleaned, inspected for serviceable condition and stored appropriately in accordance with workplace procedures
  • 3.4 Equipment and work area clean-up is maintained in accordance with workplace procedures
No information
No information
Replaced By
State Code National Code Title Type
OAK04 MSFDG2001 Assemble leadlight and stained glass components Unit of competency