Unit of competency Outline

Date retreived
22/07/2026 8:17 PM AWST

Whilst all efforts are made to provide accurate and timely information from the relevant source/documentation, please be aware that the information supplied may not be the most current version. The accuracy of the detail has not been confirmed by the Department and therefore should not be relied upon without first confirming the contents.

Carry out spot welding

Carry out spot welding

Unit of competency
National Code
AURVTW005
State Code
AWY97
TGA Status
Replaced
DTWD Status
Replaced
Current Release Number
1.00
Current Release Date
14/04/2016
View on TGA
State Implementation and Classification
Approved Date
13/07/2016
Field of Education
030711 - Boilermaking And Welding
Original Release Date
13/07/2016
Nominal Hours
20
Description
This unit describes the performance outcomes required to carry out spot welding to replace structural and non-structural vehicle body sections according to original equipment manufacturer (OEM) or authorised agency procedures. It involves preparing for the task, selecting and using spot welding equipment, adjusting spot welder, operating spot welder, selecting and using suitable personal protective equipment (PPE), inspecting and testing weld quality, and completing workplace processes and documentation. It applies to those working in the automotive service and repair industry.No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.
Notes
Elements and Performance Criteria
1. Prepare for spot welding
  • 1.1 Job requirements are determined from workplace instructions
  • 1.2 Welding information is accessed and interpreted
  • 1.3 Materials for repairs and replacements are selected and inspected for quality
  • 1.4 Hazards associated with the work are identified and risks are managed
  • 1.5 Tools and equipment, including personal protective equipment (PPE), are selected and checked for serviceability
  • 1.6 Work area is prepared and work is planned to conduct and test spot welds, minimise waste, and use time efficiently
2. Carry out spot welding activities
  • 2.1 Surfaces are prepared for spot welding and anti-corrosion coatings are applied prior to spot welding
  • 2.2 Welding equipment is set up and adjusted for specific welding job requirement following OEM or authorised agency repair guidelines
  • 2.3 Sample spot welds are performed and destructive tested
  • 2.4 Welding is carried out using welding equipment according to workplace procedures and safety and environmental requirements
  • 2.5 Spot welding is completed without causing damage to components or systems
  • 2.6 Completed spot welds are inspected for quality, and identified faults are rectified as required according to workplace procedures
3. Complete work processes
  • 3.1 Final inspection is made to ensure work meets workplace expectations and component is presented ready for use
  • 3.2 Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored
  • 3.3 Tools and equipment are checked, reported if faulty, and stored according to workplace procedures
  • 3.4 Workplace documentation is processed according to workplace procedures
No information
No information
Replaces
State Code National Code Title Type
WF579 AURVTW2005 Carry out spot welding procedures Unit of competency
Replaced By
State Code National Code Title Type
OCI79 AURVTW105 Carry out spot welding Unit of competency